![Flasutie](/img/default-banner.jpg)
- 19
- 3 376 101
Flasutie
Registrace 21. 07. 2022
Fin deployable Projectile with Wrist mounted 40mm Grenade launcher
If I could just attach a propulsion system to the rear part...
www.patreon.com/Flasutie
www.patreon.com/Flasutie
zhlédnutí: 49 096
Video
Wrist mounted 40mm Grenade launcher
zhlédnutí 342KPřed měsícem
Files on www.patreon.com/Flasutie/shop/wrist-mounted-40mm-grenade-launcher-194736 Be careful with your ears when using the M576
25mm Revolver - Hand Cannon
zhlédnutí 567KPřed 2 měsíci
Can it be used with Nerf War? Patreon - www.patreon.com/Flasutie
Upgrading HHO Impact Grenade
zhlédnutí 269KPřed 4 měsíci
Could it be used for airsoft games? Patreon : www.patreon.com/Flasutie
Howitzer style 30mm Cannon (HE part 2/2)
zhlédnutí 691KPřed 4 měsíci
The problem is that the shell is too light and has low density, so it may not even reach 100 yards. I made everything with 3D printing except screws, wires, and springs. Q: "When it comes to targeting humans, how would it fare?" A: "They might get angry. It's quite painful." Well, over the past few weeks, many people have been curious about how dangerous this can be.
Can make a 30mm HE shell? (HE part 1/2)
zhlédnutí 233KPřed 5 měsíci
In Part 2, I will make a launcher. It will probably have a shape similar to a howitzer.
Revolver Crossbow (Rapid-fire?)
zhlédnutí 37KPřed 8 měsíci
Actually, I tried to make a way to cock it with the handle, but it wasn't possible within this design. 😩 Long time no see, everyone! I ran out of ideas on what to do with ethanol. So, I deviated a bit from playing with ethanol, and tried making something that mixes a bit of the medieval with some modern technology. Because, well, it's just fun. Don't try to find a reason in this. Usually, I don...
Chain mail vs. APFSDS with polearm, spear, and arrowhead shapes.
zhlédnutí 52KPřed 11 měsíci
Everything was made with a 3d printer.
APFSDS of Soviet design and little bit of 3D printing
zhlédnutí 43KPřed rokem
#3dprinting #apfsds www.thingiverse.com/thing:5969982
Is it Shrapnel Shell?
zhlédnutí 30KPřed rokem
Designed for thin armor. But, If it has more power, i think it can penetrate more thicker one. A week for another few minutes...
Fin deployed shell (XM1147 / AMP)
zhlédnutí 93KPřed rokem
Short video! I made fin-stabilized shell before, this is different shape of that kind. #3dprinting #shell #cannon #ammunition
Hand tools, All in Gun
zhlédnutí 17KPřed rokem
From now on, almost all hand tools can be replaced by being fired from a gun. If you want build a house? Reload and Fire. Done. #DIY #gun #tools #3dprinting
See through Suppressor for Potato gun
zhlédnutí 30KPřed rokem
See Through.... Suppressor? Silencer? I have no idea. #suppressor #silencer #slowmotion
3Dprinted 20mm Mechanical APCR (feat BR-350P)
zhlédnutí 44KPřed rokem
3Dprinted 20mm Mechanical APCR (feat BR-350P)
what printer and material did you make this out of?
Ah yes the pipboy got angry ☢
"Tank Missile!"
That was pretty dangg cool, man. Great engineering! It was very well done!
вітаю! підскажіть будь ласка яку ви резьбу використовували?
Hey, wait a minute. That looks like the ULTRAKILL pistol...
Im gonna bring this to a nerf war
I’m curious about the noise reduction with these designs
女の子みてえな手してんなお前な
This thing isn't even a toy or anything anymore, This is just straight up a weapon. Imagine having a nerf war and one of the kids pulls up with this thing.
Hmmm, it’s ULTRAKILLING’ time +RICOSHOT +RICOSHOT +RICOSHOT
Make a grenade launcher
Very impressive.
Ultrakill
Destiny guardians want to know your location:
That you Hol Horse?
ngl it look like Arbiters shot from decaying winter
Average Devil May Cry sidearm:
Now barrel it and make it longer. Get a firing pin and a primer. Kaboom, Rico.
That was the coolest thing I've ever seen printed
Make it 1:1 size now
ULTRA KILL IN REAL LIFE💀💀💀
When nerf gets serious:
Decaying winter arbiter:
Why do i feel like i saw this in ultrakill😂
now make a real one, in the name of american freedom.
dankpods music
Yo, if someone comes at me with THAT in a Nerf War? Imma just surrender and go home
Will these be in the stores for Christmas?
This reminds me of those 1950's Remco vintage toys.
its the best frame because it looks like texas
Wonder if I can mod this to shoot nerf darts
This looks like it has a very high chance of sending shrapnel back into the user
Ever consider testing like an automatic? something with a gas piston? or is that pushing the limit of what you can safely achieve using hydrogen?
Slab revolver ultra kill:
Dude i dont want it, i need it
The Piercer Revolver is the first gun found in ULTRAKILL and is the blue variant of the Revolver, obtained in [ 0-1: INTO THE FIRE ]. It can deal moderate amounts of damage with its primary fire and can pierce through multiple weak targets or inflict concentrated damage on single targets with its secondary fire. Hold Alt Fire to charge a 3-hit beam. Requires cooldown. - The Terminal. The Piercer Revolver is railgun-revolver hybrid that uses electric pulses to fire microscopic metal shards at high speeds. The revolver cylinder is loaded with self-recharging batteries instead of conventional bullet cartridges, and the muzzle is a tall, glowing rectangular opening rather than a projectile-sized hole. Located above the grip is an additional battery powering the weapon's on-board display, which indicates the charge state of its alternate fire. The cylinder's chambers and display glow light blue by default, though the color will change to reflect the player's variant palette customization. Primary Fire The primary fire shoots a standard hitscan shot at a reasonably high rate of fire, dealing 1 damage. Holding down primary fire will cause the gun to fire automatically. Hitscan shots have infinite distance and no damage falloff. All stock revolver attacks benefit from locational damage multipliers, dealing 1.5x damage on limbshots and 2x damage on headshots. Alternate Fire Upon holding down, the alternate fire will begin charging. It takes approximately half a second for it to fully charge, and after firing it takes around 2.5 seconds to recharge. Upon releasing, the Revolver will fire a powerful 3-hit hitscan, dealing 1 damage per hit. This means it can either pierce through and kill 3 weak enemies or hit a single enemy for 3 damage, or 4.5/6 damage on a limbshot/headshot. A charged shot can be ricocheted off of a coin, allowing it to gain additional damage. However, instead of a straight +1 damage bonus for each coin, the charge shot will gain +0.5 damage to each of its three hitscans for the first coin, and +0.25 damage for each coin after, for +1.5/2.25/3 total base/limbshot/headshot damage for the first coin and +0.75/1.125/1.5 damage for subsequent coins. The Piercer Revolver's primary fire can still be used during the charged shot's cooldown. Strategy Early on, the Piercer Revolver can be useful for taking out annoyances such as Filth and Drones. However, after the first level, the Piercer Revolver's primary fire quickly loses its usefulness, as there are other weapons that are superior in raw damage output such as the Shotguns and Alternate Revolver and weapons that are better at crowd control and targeting weakspots such as the Marksman Revolver's ricoshots. The true utility of the Piercer Revolver comes from its alternate fire, which has a reasonably short cooldown compared to the Alternate Piercer and has a fairly high damage output when targeting the head, limb, or certain weakspots. It can be used to frequently dish out decent damage from anywhere on the map due to its hitscan capabilities. The charged shot is able to ricoshot, and can do so with greater frequency due to its faster recharge speed compared to the Alternate Piercer. While a 4-coin charged ricoshot is able to deal a respectable 13.5 damage on a headshot, four separate single-coin ricoshots can inflict 9 damage on headshots each, for a potential 36 damage total. It is worth noting that, because this method of dealing damage relies on the same two weapons, it will likely eat up weapon freshness if done back-to-back, reducing style points. When an enemy if preparing to fire projectiles, shooting projectiles right before they are fired will interrupt them, causing an explosion. Shooting rockets with the Revolver will detonate them early. Shooting cores will create a red explosion with doubled damage and blast radius. Revolvers can shoot a Sentry's antenna to interrupt it from firing, and can also instakill Streetcleaners by hitting the gas tank on their back. The other Revolver variants, however, have better and more consistent ways to instakill them. Trivia The Piercer Revolver's charged shot was once able to break the explosion-only rock in [ 0-3: DOUBLE DOWN ], allowing players to skip the first encounter with Swordsmachine. With the "NO WEAPON COOLDOWN" cheat enabled, holding the alt fire and primary fire simultaneously will cause the gun to autofire its charge shot. Hitting an enemy's head with the alternate fire counts towards three +HEADSHOT COMBO stacks at a time, due to the charge shot functionally firing three simultaneous hitscans in the same direction. Firing the revolver advances chambers two at a time instead of one like a traditional revolver, meaning the cylinder indexes through three different positions instead of six. In combination with the tall muzzle, it can be inferred that the revolver draws power from the batteries at both the 12 o'clock and 6 o'clock positions of the cylinder for its primary fire, and it follows that tapping all six batteries for the charged Piercer shot would be equivalent to three simultaneous shots of the primary fire. When holding down primary fire right after the alternate fire is pressed, the charge shot is fired right when the charge is full, rather than when releasing the alternate fire button.
Yeah if that were real, you’re arm would be gone
Now make it belt fed
ultrakill?
Now this is what i call a HANDCANNON
You should make a rc tank that shoots like an real tank
You should make a tank that shoots
8:03 XD the bullet spining
2:57 huh?
bro, this thing looks like revolver from ULTRAKILL
now turn it into the revolver from ULTRAKILL
nah, this mah daily carry
Now we need a speed loader for this…