![Vincent Stevenson](/img/default-banner.jpg)
- 967
- 7 944 916
Vincent Stevenson
United States
Registrace 9. 02. 2013
I strive to create engaging content for students, engineers, and scientists around the world. I share what I'm learning along my academic and professional paths as a chemical engineer, community college transfer student, and medical student.
I encourage you to always reference the latest publications and textbooks for the most accurate information pertaining to subjects covered in my videos. I assume no responsibility for the technical accuracy of my content. As with anything: “trust, but verify.”
I encourage you to always reference the latest publications and textbooks for the most accurate information pertaining to subjects covered in my videos. I assume no responsibility for the technical accuracy of my content. As with anything: “trust, but verify.”
How to clean corroded battery terminals in electronic devices at home - fast and easy!
I show how to clean corroded battery terminals in electronic devices like TV remotes at home using white vinegar and isopropyl alcohol. It's fast and easy, and you can do it right now at home!
zhlédnutí: 673
Video
Brake Lights Stay On After Turning Car Off - How to Fix
zhlédnutí 88Před dnem
I walk through the possible causes of why your car's brake lights stay on after turning the car off. I show how the plastic stopper is one reason, but there are others. In my case, the brake light switch itself needed to be adjusted farther forward so the button would be fully depressed when the brake pedal was not engaged.
How I passed my first plumbing rough in inspection
zhlédnutí 74Před 21 dnem
I walk through how I passed my first plumbing rough in inspection. I discuss the drain and water supply line locations and sizes, hydrostatic and pressure tests, as well as minimum slopes and sub floor cut outs for the inspector. I hope this helps!
Hydrostatic Pressure Test for Plumbing Inspection Drain Lines
zhlédnutí 47Před 21 dnem
I show how I did the hydrostatic pressure test for the new drain lines for plumbing inspection. The lowest fitting is capped with a pneumatic test ball in a clean out tee to stop the water from exiting the sewer.
How to wet vent a bathroom
zhlédnutí 66Před měsícem
I show how I used wet venting to be UPC compliant in my bathroom plumbing without needing a dedicated dry vent for a water closet (toilet).
Under Sink Water Filter System Install Guide
zhlédnutí 130Před měsícem
I walk through how to install an under sink water filter.
Lead Oakum Cast Iron Hub Joint Removal
zhlédnutí 1,5KPřed měsícem
I walk through how I removed a lead oakum joint on a cast iron pipe wye using a 1/4 inch drill bit and a flat head screw driver. This is a long and painful process, but I hope this video helps!
Training a machine learning model from scratch to predict housing prices
zhlédnutí 264Před měsícem
I walk through how to train a machine learning model to predict housing prices. Specifically, we use housing market data to train a linear regression model with scikit-learn. We explore our dataset, use stratified sampling to create effective training and test sets, impute missing data, log transform and scale our features appropriately for optimizing our training process. Finally, we discuss h...
How to find gas leaks with a detector
zhlédnutí 80Před měsícem
I walk through how to use a simple gas leak detector to find natural gas leaks.
Deck Framing Design Max Beam Span for IRC Compliance
zhlédnutí 68Před měsícem
I walk through how to determine the maximum span for beams between posts for a deck to make sure that you are IRC compliant. It's important to note the type of lumber, lumber dimensions, and joist length before consulting this table.
How to cut a floor joist for plumbing requirements
zhlédnutí 813Před 2 měsíci
I show how I cut and blocked floor joists for a bathroom addition project. The problem was that the shower pan drain was directly over an existing floor joist. I walk through how to transfer the load from the original joist through blocking and into the neighboring joists using joist hangers and structural screws.
Raspberry Pi 5 setup from scratch in under 6 minutes
zhlédnutí 299Před 2 měsíci
I walk through how to install the thermal management system, case, and Ubuntu operating system on a brand new Raspberry Pi 5 - from scratch. Here's a link to buy the unit in this video: www.amazon.com/Vemico-Raspberry-Starter-Active-Cooler/dp/B0CWL3PY7C/ref=sr_1_25?crid=2SA2RBCJZOG2U&dib=eyJ2IjoiMSJ9.XSxQmw2FI8iWDJ9dqaM7HB7Po2FcaYoKG4cEvHWJTN6ny7IO3kj1YxA8qMmDnRLW-Bl_223KRjuhSNCrn96e0g3RD1fGflp...
How to replace rear wiper blade Honda
zhlédnutí 302Před 2 měsíci
I walk through how to replace the rear window wiper blade on a Honda. This is a 2015 Fit.
How to remove a non load bearing wall
zhlédnutí 154Před 2 měsíci
I walk through how to use a reciprocating saw to remove the studs, blocking, and plates in a non load bearing wall at home.
How to Retrofit Apple Car Play and Android Auto to Older Cars
zhlédnutí 1KPřed 2 měsíci
I walk through how I got a touch screen with Apple Car Play and Android Auto on my 2000 Honda Insight with a single din stereo.
How to remove entire drywall panels professionally for a demo
zhlédnutí 343Před 3 měsíci
How to remove entire drywall panels professionally for a demo
How to install inside mount roller shades
zhlédnutí 91Před 3 měsíci
How to install inside mount roller shades
Cut Window Shade Blinds to Custom Length
zhlédnutí 256Před 3 měsíci
Cut Window Shade Blinds to Custom Length
MacBook Pro LCD Glass Bezel Replacement
zhlédnutí 542Před 3 měsíci
MacBook Pro LCD Glass Bezel Replacement
Making your first 3d printed object from scratch - full tutorial!
zhlédnutí 148Před 4 měsíci
Making your first 3d printed object from scratch - full tutorial!
How to Measure and Cut Floor Baseboard Miters
zhlédnutí 3,1KPřed 4 měsíci
How to Measure and Cut Floor Baseboard Miters
CompTIA Security Plus Exam - Review and Reflection
zhlédnutí 263Před 4 měsíci
CompTIA Security Plus Exam - Review and Reflection
How to make vent cutouts in LVP flooring
zhlédnutí 399Před 4 měsíci
How to make vent cutouts in LVP flooring
Installing LVP Flooring Along a Rough Stone Wall and Fireplace
zhlédnutí 998Před 4 měsíci
Installing LVP Flooring Along a Rough Stone Wall and Fireplace
Installing New 3/8 Inch Inset Self Closing Cabinet Hinges
zhlédnutí 2KPřed 5 měsíci
Installing New 3/8 Inch Inset Self Closing Cabinet Hinges
Thank you
what fluid did you use?
Most useful thanks. Some idiot smashed mine sometime today and drove off, unfortunately putting a dent in the panel as well. Not amused, but have a replacement light on the way.
great content exactly what i needed
If ybf/yaf=2/1, doesn't that make the molar ratios 0.3(repeating 3) and 0.6(repeating 6)? so the molar flow rates for Species A and Species B would be 410 and 820 respectively; so when you get to solving 0.3=(Faf-x)/(Faf+Fbf-3x) using 410 & 820, no solutions exist?? Also, 827/403=/=2/1
Please help me vincent
Quick note to you. Not all air conditioning outside units have an external quick disconnect mounted on the exterior of buildings. Our A-coil and compressor units were replaced five years ago. The old one did not have an external quick disconnect, so the installer did not add one.
I'm not sure that this video answers the question in the title. Maybe "WHAT is JRGB?" would be the better title. There's no real instruction here about HOW to run the cables (most especially when linking additional lights into the package). What if there's a hub (like Razer Chroma)? Does direction between the linked cables and hub have to be a certain way? What if you have a separate wire with ARGB female on one end and a wire - marked 5V+/ND - that attaches to a dedicated hub on the back of the motherboard; what do you do with that wire? These are just a couple of things that would be nice to know. I feel like the people saying that this saved their lives are of the type (which I used to be, also) that don't know where to hook it in, in the first place, and are too lazy to take the time to read the manual.
How to change the my name is (ip address) to something else?
Thanks mate. I got absolutely ripped off from a tailor last year!
How do u extract it
I don't want to call you an idiot, but are you comparing a language with an actual platform? That's pretty dumb to me.
thx dude my was pretty bad .
Brilliant simple video - really appreciate your effort!!
Vinegar is good on plastic and metal components like these. If your device has rubber seals on it (waterproof), remove the seals first or use citric acid instead. Vinegar attacks rubber but citric acid does not. You can also substitute the vinegar here with citric and they both work equally well. Just be sure to remove all the citric (or vinegar) from the device to minimise future corrosion.
This is very useful, thank you, can you please help in case I need to protect more than one page. Thanks in advance.
It did not just pop out how tf did you pull it
These darn Roku remote mine did this now I don't keep the battery in it I could put new batteries in and two days later dead I think it's crazy how this is obviously a common issue with these remotes.
After doing this a few times over the years, my solution has been to use rechargeable batteries. Yes, they are more expensive in the short term and they do not last as long between charges but I don't worry about corrosion.
Showing us the resistance of a good one would have been helpful
I can't believe you found the roku remote with batteries still in it. 🤣
Awesome! Thanks!
😮😮😮++😮😮😮😮😮☆😅☆☆☆☆☆☆☆☆☆☆☆☆☆☆☆☆☆☆☆☆☆☆☆☆☆☆so ☆much respect 🙏 ☆☆😮😮😮in 😮😮
Great story! Thank you so much for sharing your story
תרגום טקסט באמצעות המצלמה Why are you replacing this part mate
Hey man, didn't you forget to put Honda Bond?
Really helpful!👏
lifesaver
Nice! Thanks! Was looking for something simple to do for a small crafting area. It's perfect.
updated docker-compose.yml: services: www: image: php:apache volumes: - "./:/var/www/html" # sync project dir with container web dir ports: - 80:80 - 443:443 # for future ssl traffic db: image: mysql:latest environment: - MYSQL_DATABASE=php_docker - MYSQL_USER=php_docker - MYSQL_PASSWORD=password # this should live in a env var - MYSQL_ALLOW_EMPTY_PASSWORD=1 # equivalent to true volumes: - "./db:/docker-entrypoint-initdb.d" # sync persistent sql files with container phpmyadmin: image: phpmyadmin/phpmyadmin ports: - 8001:80 environment: - PMA_HOST=db - PMA_PORT=3306
<3
Can this be done on lambda
After seen your vidoe I finally fix my honda civic 2005 and Mechanic was gnna charged me 800 for the computer when it wasn't even that!! It was the Air Fuel sensor!!!
I'd be interested in a followup regarding how this all worked out for you. I've been puzzled at how many people describe major thermal expansion of boards, resulting in expanding gaps during the winter and twisting when boards have nowhere to expand.
That car sounds like it has a manifold crack
satisfying👍👍
If I get this problem in the exam, I will skip it.
Three years later, still works. Thanks bro 🙇🏾
Much thanks, right to the point, saved me a literal headache. The only other thing I can add is to have some earplugs handy.
Why do the pads need to be pulled out of the caliper?
All that study and most general doc. are simply utilized as pill pushers. Fast, fast, fast diagnosis and here is a pill and a billing code that goes with that....NEXT. Sad but true. ER is obviously different. SO smart but they NEVER talk Nutrition and Exercise. Corrupt industry. See The Flexner Report. They admit it.
Ima try it but like thay for like last 4 momths
I just changed my CVT fluid. I still made a mess but not as bad as yours lol. Thank you for all the DIY video, very helpful!
CV axles are the definition of "the devil's in the details". When they go easy, it almost happens automatically. When they don't, though...
Nice, thank you so much 🙂
Unfortunately this tutorial only works if you want to run it on your device or others' device through localhost, you can't deploy it to a remote host. :(
If anyone is trying to deploy a full-stack PHP, MySQL, and Apache Web, refrain from using Docker if you don't have a solid understanding of it. I found this playlist of tutorials to deploy it through a Linux VM (DigitalOcean droplet). This is better if you are a beginner. www youtube com/playlist?list=PL4apNHBRJVlQ56Pj3BS2CfxhavTAV3MLd
Instead of wd40, just use your spit. It works well
Thats part of getting any higher degree. Medicine is the toughest. You can either do it or you cant. The issue seemed to be your study strategy. There are online guides on how to approach medical school. Of course you will work weekends.
It has nothing to do with a study strategy, if you have nothing good to say then keep it to yourself
Does anyone know a way to level the cabinets for backsplash AFTER the countertop has already been installed? My cabinets were not level but the stone installers installed the countertops anyway and then said they couldn’t add backsplash because it’s level. They won’t own up to it - what can I do from here?
Just wanna say thank you , this walkthrough was perfect and my ac is back up and running
It worked! Press F to pay respect.
😂😂😂 PRO TIP A real professional tip is to replace the seals when you replace the shafts 😅