Video

Can you install in a 2023 Peterbilt 389...????

Where are you located?

Ok are you putting the can between the metal bumpstop thats higher than the U bolts and stop thats bolted to the upper frame? the. Or does the can just need to fit between the u bolt closer to brakes and the upper frame stop. How about put can where it should fit leave it there and video of just that along.

Can you check the ohms while it's still installed via the connector, or do you have to pull the unit out for testing?

Why does the engine block need to be drained ?

Great vedio as always, my question is, if i bypass the sleeper heater core, would the front one still work? Thank you

Insert only by hand..

How much cost that labor? Thanks, very good learning video

Where you locate homie?

Can I replace it without doing that prime computer thing I’m replacing it on the side of the road

thanks

Sooo. Like a dumb a** I fought everything in the way and didn’t take off the mudguard for three days. I wish I would’ve watched this before hand. This fix was NOT fun. Glad I did it myself but wish I did it smart.

❤❤❤

What’s does hoses part # thanks this video I thought it was hoses leaking 😅

My belt came off and the whole thing moves from back at the bracket.

How much was the jack and what's the lowest ton jack i can used to get the job done

Wouldn't happen if these cheap chinese made plastic and aluminum radiators were still made out of copper and brass that freightliner is charging a premium for

Please upload a video how to install a air compressor dd15

Any one help I have code 111-18 111-4 I change coolant tank and sencer

Where are you located Plz..Thy

Thy..Thy part numbers..BIG help Sir

New mechanic here. You honestly saved me so many hours of agony, trial and error. Thanks for posting this.

I have a question. I got a 2016 Freightliner cascadia dd13. The codes that came up are SPN 91 FMI 8 and code SPN 111 FMI 3 could the CPC cause those codes?

What’s the part number of the seal tool.

What size fittings do I need to take each part off. Thx

Is the right height for a 2011 freightliner Cascadia, the same

❤❤❤❤

How can test the relay fan clutch?

Very detailed instruction, thank you very much

❤❤❤

If I disconnect that sensor is it gonna prevent from automatic turn off, or should I buy extended wire and move sensor inside in can and put it on 20 Fahrenheit or put it on 100 Fahrenheit in oven? Is it gonna prevent from turning off engine

Excuse me please what’s part # for second part for fitting

I replaced my starter on my m2 cause my old starter was wasnt cranking. Just one “click or clank” sound. Replaced starter solenoid, battery & fuses. Still have the same issue. What the hell could the problem be ?

Thanks for the help !

Is this process good for carhauller peterbilt ?

No sealant on the gasket?

When I mentioned height control valve I’m talking about the valve with the 2 screws. Just wanted to make that clear. Please please help. Also, it seems as though the airbag that’s right under the valve (front right) isn’t extended at the nipple as the left front airbag. What could be the cause of this as well, could it be my leveling valve not sending air equally to all bags?

Hello! I have a 2018 Freightliner Cascadia JSJY1055 and I have been watching to try to set my leveling valve. I’m noticing that you said that once you get to 2 3/8 to clock it down and tighten the screws. My measurements per freightliner is 2 5/8 but I believe your video is the same for my truck setup. When I lift my height control valve up if I’m too high my frame goes down…is that correct or should my frame go up when I lift the valve up? Not the linkage but the valve. Then when you say to clock it down, can you further explain what you’re saying? For some reason my setting seems to move and not stay where I’m setting it. I very much need your help with this. I’ve paid out $30k last year because no one was able to find my problem which was left rear motor mount. So because of that so much has been replaced, removed or tweaked trying to find the problem. Thank you in advance.

Whoa, glad I watched this. This will not fix a leaking cascadia window!

You are my hero man😢 thanks a lot, I appreciate your help 😊 You saved my bucks 😅

Awesome job man thanks

I liked that music in the background, that really adds up and helps a lot

What to do if after replacing the valve nothing changes? The truck keeps surging

Support the drive axel

Thanks!

Does anyone know what that connector part number is. 2023 freightliner cascadia here.

Awesome video brother. I listen to the same music while I'm working lol. Found your video while trying to put my hub back together. Keep up the good work.

another excellant video, really appreciate your videos

❤❤❤

My u joints ok keep falling off every 2k miles or so dunno what it is