How to Change Alternator on Toyota MR2 SW20 MKII

Step-by-step instructions for replacing the alternator on a Toyota MR2 SW20 MKII. It’s a tough job but very do-able with a little patience and elbow grease. The hard part is getting the old alternator out (tight squeeze) and the new alternator in.
Tools needed:
Sockets: 10mm, 12mm, 14 mm
Ratchet
Socket extensions
Jack
Jack stands

[@manny7868]

guysss oh my days real pain to find out how to remove it and you guys just blre my mind off thanks so much 😘

[@RickiMcKay]

8:55 Its easier to refit the alternator to the holder if, while the holder is out, you punch back a few mm the washer/spacer on the holder (visible top right at 4:40). This makes space for the alternator to drop back into the right position.
The washer/spacer tightens back up when the bottom alternator bolt is tightened.
Much easier job than anticipated, definitely easier than other methods like removing the exhaust.

[@warrenpeas]

can you just sand the alternator down a couple millimeters so it fits easier and leave the bracket in?

[@rustyshackleford8326]

where does the other ground wire go (square one) that sits next to that ground wire on the alternator on the harness, i removed this awhile ago and cant seem to remember, please help

[@didthismeyouto3839]

I know this is an old video, but how did you remove/tighten the alternator belt?

[@rockycassiano4756]

I got a 91 turbo.... Alt. bracket bottom bolt is, 'BEHIND', the right-rear-axle-carrier. How did you get it off without pulling the axle?

[@grantcanty7294]

how did you guys get the alternator clip out?

[@edwardgarforth11]

Having trouble removing the alternator from the frame, I've removed the bolt and it swings left to right loose but it seems like it's stuck on a hinge and it won't budge (its quite stiff moving but still moving now, had to use a lot of force to get this out into the now swinging position)

[@marconoriega774]

Use a flat head to pry it out.

[@edwardgarforth11]

@@marconoriega774 I used a piece of metal to hit it out of place, it's a completely fused alternator. I was using a flat head to pry it out but it felt like I was going to snap the screw driver, so I just used a long piece of firm metal to smack it out of the hinge and boom done after like 50 hard hits

[@kzukiodenthechad7205]

The real question is, where can you find the right alternator for the SW20 MR2

[@philliphurd]

Rock Auto has them

[@warrenpeas]

did u find one? they sell them on amazon but i dont know if they are trash or not.

[@kevinedwards9365]

I just thought my 91 was difficult.

[@Pow3rus]

What the hell I don't have the same engine at all

[@matyasbekefi7238]

You probably got a 3sfe, because the one it the video is a 3sge. :)