Sportster Build - 2005 Harley Sportster Bobber - Part 5

This project is almost wrapped up. After the wiring is done, there's just a few loose ends to tie up and The Windy City Special will be ready to hit the mean streets to grab an Al's Beef.

[@chriscaine1776]

Ive been watching this series since it popped up. 2 notes on the wiring, twisting the wiring actually will help it to be less rigid once youve loomed it, and also if you melt the fibers of the loom together and tape the wire ends before putting them through it will help prevent fraying

[@ChucksCycles]

Thanks, I now melt the end of the loom before sliding it on, it works much better.

[@77xlchop]

cool wiring schematic! (8

[@ChucksCycles]

Thanks. It works..... so far, haha

[@HarleyFurgesson]

If you use a pollak ignition switch you can eliminate the relay for the starter, the relay was only used due to the fact the standard controls used a momentary switch that would not be strong enough to accept the amperage the starter field wire requires. 👍🏻

[@ChucksCycles]

Cool, Ill look into those. Always looking for better ways to do things.

[@sheilalucas9154]

Great lesson on bike electrics. Paul Lucas. UK.

[@dtr6432]

What would the wiring process look like for a single fire coil? I got the ultima ignition, and im having trouble getting it to want to time. On my key switch it has SCAMB and one other. What would the IGN equivalent be?

[@maxbayko8666]

Where do you buy your spade connectors?

[@ChucksCycles]

They came with the relay blocks. I think I got them off Amazon.

[@davemurrell2366]

👁️ ❤ 👻🐝🐝