'03 Intruder-VL 1500 LC-Carbs-Fuel into Air Box
Vložit
- čas přidán 31. 07. 2016
- Getting fuel sprayed into air box and filter. Sliders vibrate when throttle blipped. No increase in rpm when sliders pushed back manually. My first tiime uploading a video here, so, let me know if video does not play well.
- Auta a dopravní prostředky
I've since found out, that, aftermarket stainless needles were installed when the V&H Longshots were installed ....the stainless needles where the emulsion tube orifices into an egg shape, causing fuel to basically overflow into the carbs. The only cure is to remove/replace the emulsion tubes, which can only be done by two people, apparently, since the tubes are not available from Mikuni for replacement. V-Twin Thunder, in California and Gman Industries in Washington state. Mechanics I've talked to here in Ontario, Canada say the pressed in tubes were the worst idea Suzuki/Mikuni ever had ...gotta agree...new replacement carbs cost nearly $500 each here!! ;(
Roaddawg 52 hey I have 2000 Suzuki intruder lc 1500 and it's been down for a long time and I'm finally putting it back together and I don't know where the air vent hose hose goes too can you help me out please?
Roaddawg 52 where is that black hose in the center of the carbs going too
Same bike why is leaking gas from the small hose the is between?
@@broderickhammondsful little late but into back of unit behind chrome piece on right side of motor .
I have an 87 intruder 1400
Gas also pouring form the rear carb in to the airbox causing a leak from the overflow.
I’ve had the carbs rebuilt with no luck.
Any help would be appreciated
Shim up the stock needle's and adjust the air/fuel idle jet to match the higher flow exhaust. The carbs are fine, the kit is is wrong!
You also may want to (if you didn't already) eliminate the air by pass system.
How do you do that?
@@stevetrent4753 do u know how to remove it ?
@@full_metal_everything6929 I haven’t ever done it .