Hausted® Fluoro-Track Stretcher

Sdílet
Vložit
  • čas přidán 11. 09. 2023
  • Introducing the Hausted® Fluoro-Track Fluoroscopy Stretcher
    The Fluoro-Track™ stretcher is designed to offer the security of the treatment table and the mobility of the transport stretcher and for use with C-Arms for fluoroscopy-guided procedures. The unique design, with a proprietary sliding top, enables a broader range of imaging capacity without repositioning the patient. The chair has a 500lb wt capacity allowing for use in multiple procedures, patient treatment, transport, and recovery. This stretcher is designed with a full-length Radiolucent translating top that is easy to operate to enable a broad range of imaging capacity without repositioning the patient increasing the imaging access where the clinician needs it. The translating top has 18 inches of movement. Raise the rails to a high position and On the Patent Left pull on the RED Lock tab or safety pin and Raise the Release tap to engage the top 12 inches towards the foot and 6 inches towards the head. This movement reduces the amount of repositioning of the patient and the C Arm, allowing for shorter procedure times. After the procedure is completed the Patient surface must be returned to the Center position.
    The standard on the unit is the 8-inch Tente Caster with central brake and steering. The caster braking system should always be locked when the patient is not in transport. The caster braking system should always be locked and the patient side rails in the upright locked position when the patient is left unattended. This system makes steering and braking easy and safe for staff and patients. Red pedals for braking and Green pedals for steering. Located on all 4 wheels. The Low profile base creates an excellent window for C-arm access from both sides. The Fluro track stretcher has a width of 24 inches, Allowing full access via the C Arm opening for lateral imaging. The Fluoro-Track™ stretcher has three sets of foot pedals. One set each on the Right, left, and foot end of the stretcher. The foot end set of foot pedals is conveniently located so that while C ARM is used all foot pedal functions can be performed. To Adjust the height of the stretcher: Press the large pump pedal to the floor until height is achieved. To Lower the top Press down the two release pedals at the same time until the litter is at the desired height. Trendelenburg can be achieved by pressing down the release pedal closest to the head end until you have reached the desired position. Reverse Trendelenburg can be achieved by pressing down the release pedal closest to the Foot end until you have reached the desired position. To move the fowler either up or down, press the red release handle and move the fowler to the desired position, then release the red handle. The rails of the 493RPC series stretchers can be adjusted into 3 positions. It can be raised to full height, intermediate height, and fully stowed. The 3-stage IV pole is located on the patient's Right foot end. The 493RPCST Fluoro-Track™ stretcher Contact your Hausted representative to see how the EPC500 can streamline your caseload and transform your OR.

Komentáře •