Change the Coding on your HSE2 / HSE4 Remote Bi-Secure to Fixed Code for your Hormann Garage Door

In this video we shall demonstrate how to configure your Hormann HSE2 / HSE4 remote so it is compatible with the older series of Hormann door openers.
----------------------------------
Please visit us at:
www.easygatesdirect.co.uk/store/
For all your documentation needs visit:
manuals.easygates.co.uk
Facebook: / easygatesdirect
Twitter: / easygatesdirect
LinkedIn: / easygates-ltd
Copyright © 2022 EasyGates LTD. All rights reserved.
This video is subject to copyright owned by EasyGates LTD. Any reproduction or republication of all or part of this video is expressly prohibited, unless EasyGates LTD has explicitly granted its prior written consent. All other rights reserved.
The names, trademarks, service marks and logos of EasyGates LTD and or the sponsors appearing in this video may not be used in any advertising or publicity, or otherwise to indicate sponsorship or affiliation with any product or service, without prior express written permission from EasyGates LTD and the video sponsors.
Neither EasyGates LTD, nor any party involved in creating, producing or delivering information and material via this video, shall be liable for any direct, incidental, consequential, indirect, or punitive damages arising out of access to, use of or inability to use this video, or any errors or omissions in the content thereof.

[@harmnouwens6803]

thank you for this! It works! This is not in the manual when you order a new remote. Should be!

[@houlbt]

Helpful short video - thanks !

[@EasyGatesDirect]

No problem, glad it was helpful!

[@MsPepemc]

One of my remotes was stolen. How do I create a new frequency for the remotes and the otherone that was stolen, do not work if someone tries do get in?

[@EasyGatesDirect]

Hi @MsPepemc,,
Thanks for the comment. We would suggest you carrying out a full deletion on your garage operator. This process will be different from system to system, but if you let us know the model of your operator, we can help find this out. we would also then recommend resetting one of the existing remotes before learning these back into the operator. To reset the transmitter with a new code, please see the below instruction on how to do this.
Each hand transmitter button is assigned to a new radio code by means of the following steps.
1. Open the hand transmitter housing and remove the battery for 10 seconds (see section 5.1).
2. Press a circuit board button and keep it pressed.
3. Insert the battery. - The LED slowly flashes in blue for 4 seconds. - The LED flashes rapidly in blue for 2 seconds. - The LED is illuminated blue for a long time.
4. Release the circuit board button. All radio codes are newly assigned.
5. Close the hand transmitter housing.
We hope the above information helps! Any other queries, please let us know.
Many thanks
The Easygates Direct Team

[@chrirep]

Hi, is it possible to reverse the procedure from fixed to rolling code? I've tried but it doesn't seem to work. When I reset it now it only blinks red (not blue anymore) please help 🙏

[@EasyGatesDirect]

Hi Chris, Thanks for the comment and apologies for the delay in getting back to you. This process can be reversed. You simply need to do everything in the video up until the point you insert the battery. However, this time instead of releasing when the red LED goes solid, release the button when the Blue LED goes solid.

[@chrirep]

@@EasyGatesDirect thanks, I finally managed to reverse it. Unfortunately the new remote came with a low battery and had to replace it first. That's why it only blinked red when I tried to reset it thanks again