I have a rx6600 and ryzen 5 5600. Would this be ok u think for 1440p? I want a new monitor as I have 2 1080p ones now. The 5700xt is similar to 6600 but AMD says 6600 is better for 1080p high gaming?
Its hard to say what it could be, can be a improper seated CPU, RAM Or some other component. Does any debug lights turn on the motherboard? That’s the only way to kind of figure out what part is causing the problem. Resetting CMOS could also help, or if nothing works try booting up the motherboard without the RAM, GPU, SSD connected and see if it works that way ? Good luck 🤞
Do you think that a 550 watt psu would be enough? I would like to do a cheap upgrade to my 1050 ti ryzen 3 1200 PC. I would like to by the Ryzen 5 5600 CPU and rx 5700xt GPU, with 16gb Ram.
Hey, that would be a nice upgrade! It’ll be enough as long as you don’t plan on overclocking or increasing the power limit of any of your PC’s components. 600w is minimum recommended PSU for the 5700xt. I wouldn’t risk using a 550w PSU if it’s not 80plus bronze rated at least (Also the 5700xt requires two 8pin PCIe power connectors)
Thank you ! This case has decent air flow and it’s full ATX where the matrexx 40 3fs is micro-ATX. Now it all comes down to what size motherboard you’re getting
@@ankitahlawat4795on the 4 pin system fan header. You will see it’s possible due to the the header set up. Allowing for the one pin to not be connected
Hey ! Seems like only other FAN header besides the CPU header on your motherboard is on the left side of your motherboard’s CMOS Battery. Depending on your needs, you might have to get a FAN HUB. Thanks for Commenting 🙌
Bro, I need some help. Where do I plug the last daisy chained 3 pin fan connector on the motherboard? I got gigabyte B650 aoras Elite AX Motherboards. Also, Do I need a separate connection for the blue RGB light?
Go in bios & check if fans are on DC or PWM. Switch between both to see if it makes any difference. Try messing with the fan curve. If nothing works, then You could try unplugging the fans from the Y harness that chains all fans together and try plugging them one by one onto the motherboard to see if the fans are defected or if it’s the Y connector. Good Luck !
Hey ! That is strange. Maybe you have the GPU mis aligned. Use the screws meant for gpu (they are same as type as Power supply screws) and you shouldn’t haven’t any issues 🤞
@ChannelGamingTech did you use screws that the case provided for the psu? Or did you have screws from the psu manufacturer. Because otherwise I dont think deepcool provided any screws
@@JeffCollins05 it was a pre built and the gpu was used idk how but the metal part was like flipped in a way where it works but not optimal the PC that I got didn't come with any screws the only thing is the the original bracket had 2 thumb screws so I checked this video to double check if I'm wrong yes I was wrong so the way I put it made it so if I don't have any screws it I used the brackets thumb screws but because of that I can't access my display port and I can barley access my HDMI port
Fans came daisy chained out of the box. Fan LED’s might flicker due to not getting enough voltage. You can either change from PWM TO DC or vice versa to run them at higher speed (which stops flickering) Or you can undo the daisy chain for front 3 fans. Daisy chain rear fan with 1X front + 2X front fans on separate daisy chain This will also stop flickering issue as there is only 2 fans per header
a vos no te parpadearon? a mí me quedaron parpadeando lo ensamble ayer, pero creo que tengo que ponerlo en pwm desde la bios, ya que se apagan cadda 15 sg y se encienden
@@Mili___69 Van conectados los 3 por puente y el ultimo une a la mother en un conector de 3 o 4 pines, pero no podes controlar la velocidad de estos, asi que quedan al maximo funcionando o te van a parpadear
Since these are 3 Pin DC fans. Lowest RPM without the LED flicker is around 800 RPMS. Anything below that fans flicker. Solution is to either run them full power or dial them down in BIOS
Hi, i have the same case, my front fans keep switching the light on and off like yours in the video? Thats standard or can i fix?
Yes you can fix it. Change Fan from DC to PWM Mode in Bios ! Or vice versa
@@ChannelGamingTech i change it to pwm now it works but the fans are at top speed kinda lowd. Can i make them slower?
@@KLAUSSTV thats good ! Yes you can adjust the speed by doing a manual speed curve on your fans !
@@ChannelGamingTech thank u brother. Wish u all the best!
Thanks bro ! 💪
Nice build bro!
22:28 I bet you got a fright here 😅
Thanks bro 🙏 haha yes
PC build + ASMR
Great build enjoy it my man!🔥👏🙌💪
Thank you 😊🤜🤛
very helpful, thank you
You’re welcome :)
you’re a good men!
Great video
Thank you 😊
Nice system friend!
Thank you 😊
@@ChannelGamingTech It was my pleasure to watch friend!
I got the same setup, still rocks in 2023 at 1440 dpi
Hell ya !!
I have a rx6600 and ryzen 5 5600. Would this be ok u think for 1440p? I want a new monitor as I have 2 1080p ones now. The 5700xt is similar to 6600 but AMD says 6600 is better for 1080p high gaming?
@@iDeker a 6600 wont cut it bro. I can barly run cyberpunk in 1440 dpi at 40 to 50 FPS. You have to go 6700 xt for a steady 60 FPS in 1440dpi.
The Ryzen 5 3600 can run 3600Mhz ram with no issues at all. I have 32Gb @3600Mhz on the same CPU.
Good to know, thanks :)
the ram installation is so relateable😭
🥲😂
mine switched on for 5 secondes than switches right off ... what could be the problem mate ?
Its hard to say what it could be, can be a improper seated CPU, RAM Or some other component. Does any debug lights turn on the motherboard? That’s the only way to kind of figure out what part is causing the problem. Resetting CMOS could also help, or if nothing works try booting up the motherboard without the RAM, GPU, SSD connected and see if it works that way ? Good luck 🤞
We’re all the case fans daisy chained so they all plugged into 1 fan header?
thanks
You’re welcome :)
question, after finishing with the XMP profile setup, what do I do?
when did you connect the fans? i could not find the moment you did so lol
@@stefann1989 13:37
@ChannelGamingTech thank you so much! keep up with good content
@@stefann1989 Anytime ! Thank you 🙏
Did you forget the thermal paste!!??
No I did not, it’s pre applied on the stock cooler :)
the aio cooler arctic liquid freezer III fit in the top? is very thick
Do you think that a 550 watt psu would be enough? I would like to do a cheap upgrade to my 1050 ti ryzen 3 1200 PC. I would like to by the Ryzen 5 5600 CPU and rx 5700xt GPU, with 16gb Ram.
Hey, that would be a nice upgrade! It’ll be enough as long as you don’t plan on overclocking or increasing the power limit of any of your PC’s components. 600w is minimum recommended PSU for the 5700xt. I wouldn’t risk using a 550w PSU if it’s not 80plus bronze rated at least (Also the 5700xt requires two 8pin PCIe power connectors)
Hello great video. A question- is this case better than deepcool matrexx 40 3fs, I'm getting both at the same price so confused?
Thank you ! This case has decent air flow and it’s full ATX where the matrexx 40 3fs is micro-ATX. Now it all comes down to what size motherboard you’re getting
helpful video! but where did you connect the rgb switch button??
Thank you ! Fans that come with this case do not require separate RGB cable. Fans are only single colour LED. These are 3 pin fans (DC)
Where do you plug the 3 pin daisy chained fan on the motherboard?
@@ankitahlawat4795on the 4 pin system fan header. You will see it’s possible due to the the header set up. Allowing for the one pin to not be connected
the 360mm aio arctic can fit in front? Is more thick than normale rad of aio, can you please check?
The blinking lights thing happens to me
Please check the pinned comment on this post. That can be easily fixed :)
hello i have the same motherboard and i have 3 orange dioes glowing all the time on the back just like you. It should be like that?
Hey bro, I need some light here, I have the same case but I'm lost connecting the fans, my motherboard is an Asus A320M-K, Thanks in advance.
Hey ! Seems like only other FAN header besides the CPU header on your motherboard is on the left side of your motherboard’s CMOS Battery. Depending on your needs, you might have to get a FAN HUB. Thanks for Commenting 🙌
The fans have PWM or they just turn on and stay at 100% all the time?
Bro, I need some help. Where do I plug the last daisy chained 3 pin fan connector on the motherboard? I got gigabyte B650 aoras Elite AX Motherboards. Also, Do I need a separate connection for the blue RGB light?
plug it in 4 pin connector, it will work
а какой брать блок питания под эту сборку?
Does this mobo have argb header.
Also, does the Chasi fans are those uni color rgb or aRGb fans
Yes the mobo has argb headers. This case only comes with static 1 colour fans (3pin dc)
What kind of fan connectors does this case have? Thanks in advance!
Hello. Case fans use 3 Pin connectors. Not 4 like the cpu cooler
Can I plug the 3 pin fan connector at the end and put it in sys_fan1 4 pin connector?
I have the same but two of the three front fans are not working what should I do bro :(
Go in bios & check if fans are on DC or PWM. Switch between both to see if it makes any difference. Try messing with the fan curve.
If nothing works, then
You could try unplugging the fans from the Y harness that chains all fans together and try plugging them one by one onto the motherboard to see if the fans are defected or if it’s the Y connector.
Good Luck !
Hey did you have to buy any fan splitters for the case?
Not at all !
@@ChannelGamingTech so they were daisy chained meaning that only took one port?
@@frzynx correct!
Listen bro i have tge same case and i did the gpu wrong i used the thumb screw to hold the gpu but now i cant access my display port
Hey ! That is strange. Maybe you have the GPU mis aligned. Use the screws meant for gpu (they are same as type as Power supply screws) and you shouldn’t haven’t any issues 🤞
@ChannelGamingTech did you use screws that the case provided for the psu? Or did you have screws from the psu manufacturer. Because otherwise I dont think deepcool provided any screws
@@JeffCollins05 it was a pre built and the gpu was used idk how but the metal part was like flipped in a way where it works but not optimal the PC that I got didn't come with any screws the only thing is the the original bracket had 2 thumb screws so I checked this video to double check if I'm wrong yes I was wrong so the way I put it made it so if I don't have any screws it I used the brackets thumb screws but because of that I can't access my display port and I can barley access my HDMI port
@@JeffCollins05 oh I have the deepcool pf 650 so it wouldn't give my screws or would the screws be from the case
Were all the fans daisy chained that they were connected to one? Please let me know
Fans came daisy chained out of the box. Fan LED’s might flicker due to not getting enough voltage.
You can either change from PWM TO DC or vice versa to run them at higher speed (which stops flickering)
Or you can undo the daisy chain for front 3 fans.
Daisy chain rear fan with 1X front
+ 2X front fans on separate daisy chain
This will also stop flickering issue as there is only 2 fans per header
@@ChannelGamingTech thanks man
@@frzynx no problem!
@@ChannelGamingTech When you change the settings of the fans, do they make more noise or remain quiet?
@@jabmorme2455 faster = more noise but it’s not that bad
Is your psu still okay sir? You still used the set?
Yes of course is it okay. It is excellent actually ☺️
Hola podrás mostrar cómo conectaste los fan cooler ??
a vos no te parpadearon? a mí me quedaron parpadeando lo ensamble ayer, pero creo que tengo que ponerlo en pwm desde la bios, ya que se apagan cadda 15 sg y se encienden
@@Mili___69 Van conectados los 3 por puente y el ultimo une a la mother en un conector de 3 o 4 pines, pero no podes controlar la velocidad de estos, asi que quedan al maximo funcionando o te van a parpadear
are the fans noisy?
Not really, blends in with the background at normal gaming load
AMD has D.O.C.P not XMP
Fans rpm?
Since these are 3 Pin DC fans. Lowest RPM without the LED flicker is around 800 RPMS. Anything below that fans flicker. Solution is to either run them full power or dial them down in BIOS
fan is molex or 4 pins ?
3 pin (dc)
@@ChannelGamingTech ok thanks and the led ?
@@Saiiki811 fan led’s run off the same wire (doesn’t have separate cable for it)
@@ChannelGamingTech ok thanks