ZF 8HP 45/70 TCM modification with Ryutech PCB

Introduction on how to open and modify 8HP TCM for standalone gearbox control unit.
Follow us on: / ryutechautomotive

[@xr500t]

That was a Masterclass in Soldering!

[@stevekelly5166]

Ooh this was painful to watch for many reasons. I've got one of these gearboxes. No idea what this modification is for, but I can solder, I'm an engineer, Painful. Use a toothbrush to leave any metal filings on top of the old circuit board? Mental.

[@jdmtechllc6589]

Can you do this for a 6hp?

[@luv_xxx2770]

hi sir this modification for what

[@adalbertbusch70]

Maybe you don't know ZF6HP26 Audi pinout wiring?

[@octocruz2246]

Do you get any codes from doing this?

[@RS-lt2ue]

@ryutech_automotive is there a difference in PCB between an HTG and a Turbo Lamik? The reasoning behind the question... Let's say, I'm using an HTG TCU, then decided to switch to Lamik. Will there be a difference between the circuit boards?

[@ManpreetSingh-mn2lp]

Can you please send me 8hp70 pcb

[@digitalme4404]

Question: Did you replace the 4 plastic rivets when finished?

[@michaellecompte1889]

Do you like turbo lamik or HTG controller better? And why?

[@rayjones3473]

Nice work man iv just plugged in my turbolamik and i have a short to ground fault on speed sensor 2 do you think i possibly messed up with the soldering or mashed the sensor putting it back together

[@Amaxauto]

Hi! Great job! Is it works with standard bmw software? Can I use this instead of programming the transmission immo?

[@fayobam_mech_tronics]

Can this be done for Benz 722.9 the control strategy seems simple enough

[@Technical_Guruji525]

Hii

[@user-gk9dp2ez3u]

피시비 판매 하시나요