How To Install A Clutch Lockout On Banshee

How To Install A Clutch Lockout On Banshee
Subscribe 👉 bit.ly/RedoBans...
REDO-PARTS SHOP - redo-parts.com...
If you find this video helpful, make sure to drop a like & leave a comment down below!
➖➖➖➖➖➖➖➖➖
How To Remove And Inspect Banshee Clutch Cover And Clutch:
• • How To Remove And Insp...
➖➖➖➖➖➖➖➖➖
Subscribe 👉 bit.ly/RedoBans...
Extra keywords (don't pay attention):
four wheeler,4 wheeler,restoration,restore,custom,quad,dirt bike,dirtbike,banshee,banshee 350,yfz350,yamaha banshee,how to change a clutch,how to change a banshee clutch,banshee clutch change,yamaha banshee clutch,banshee clutch mod,aftermarket banshee clutch,yamaha banshee build,banshee bad clutch

[@davidreed4320]

Great video

[@RedoBansheeParts]

Glad you enjoyed it

[@hectorramos8039]

hello friend I have a problem in my 2006 yamaha banshee when I put the first one it turns off that could be?

[@conniestevenson226]

@Mske keeps clutch from slipping under power.the faster it spins the harder it makes the clutch bite

[@kodyhowe2729]

What about using feeler gouges to set the correct and even gap between the back of the lock up and pressure plate?

[@RedoBansheeParts]

Unnecessary tighten them in a star pattern evenly and you won’t need a feeler

[@hectorramos8039]

The pancake it's necessarie change ?

[@mr.rem2609]

Im looking at doing this to my banshee. I guess you can use your stock cover with this?

[@RedoBansheeParts]

You would need a lock out specific cover for most.

[@jayshafer16]

how do you adjust the pancake bearing when using a lockup? Do You have to install the springs and the screws first to tighten it down? If so, how do u get to the lock nut for the pancake bearing to adjust it with the lockup in the way???

[@RedoBansheeParts]

You can use a crows foot if you are having a hard time with reaching behind the jam nut

[@ramiropenuelasmonje4059]

Para que le sirve eso amigó?

[@Jasonsito]

Ramiro Peñuelas monje Un clutch más fuerte Para los banshees alterados

[@calastrcas]

Ramiro puñelas eso se usa cuando alteras un motor de banshe 4mm o más para que el clutch se apriete más y aga mas presión y no se patine el clutch ala ora de arrancar

[@phillyboydicez8244]

You never finished explaining how to adjust the disengagment mechanism

[@RedoBansheeParts]

czcams.com/video/sbr8fZTEFNI/video.html is a video on adjusting the stock. Its the same but you need an extra wrench to hold the adjuster from spinning while you loosen and tighten the jam nut.