Qolsys IQ Panel 4: Change Panel Brightness

In this video Dylan from Alarm Grid shows you how to adjust the screen brightness on the IQ Panel 4. To adjust the brightness, tap the gray bar at the top of the panel screen. The gray bar is located just above the time and date. This brings down a menu and you can see a slide adjustment for both the volume and the screen brightness. In addition there is a Nighttime Mode feature that you can use to turn off the screen at night.
00:00 - Introduction
00:34 - Adjust Brightness
01:22 - Nighttime Mode Setup
03:15 - Outro
The Nighttime Mode feature is enabled by default and begins at 11:00 pm and ends at 6:00 am, though the times can be adjusted. During Nighttime Mode, certain aspects of the system can be muted or disabled. This is particularly helpful if the panel is mounted in a bedroom or near a baby's room.
By default, only the display is disabled during Nighttime Mode. You can also disable Voices, Chimes, and LEDs if you want. That means, from 11:00 pm - 6:00 am (or whatever start and stop times you set) the display will be dark, and if enabled, there will be no voice annunciation, no chimes, and no LEDs lit. If you touch the display, it will wake up, and if an alarm occurs, it will be treated as any normal alarm with full display and sound.
With the information in this video, you'll be able to adjust the screen's brightness. You'll also be able to set up Nighttime Mode with your preferred options. If you deselect all options (Display, Voices, Chimes, and LEDs) you will disable Nighttime Mode, regardless of the start and stop times selected.
www.alarmgrid.com/faq/what-to...
alrm.gd/get-monitored

[@iashbanen]

Can u make a video on how to do hard wired zones for a 2GIG gcx

[@MariaLuisa-ku4bx]

Is there a way to turn off the green led lights completely? Not necessary for night mode

[@DKAlarmgridSupport]

Yes, there is an option to disable the LED indicators. Use the drop down menu to go to "Settings", "Advanced Settings", Enter in the installer code (1111 is default), Tap "Installation", Press "Installer Settings", Search for "LED", using the search feature and then uncheck the box for "LED Indicators".