Mercedes w203 C class Windshield Wiper Motor / Test and Replacement
Vložit
- čas přidán 29. 08. 2024
- Here is a link to a playlist with all the videos I made about this car :
• Mercedes w203 C class ...
Before replacing the windshield wiper motor, it is worth trying to test other components of this system. The fuse , relay and the wires might go bad before the motor itself will go bad . This procedure might be similar with many Mercedes from the year 1998 to 2006 - w203 w210
Disclaimer :
This youtube channel :"doit_vehicles " can not guarantee that this information suits to your car . "doit_vehicles " assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk .
Very detailed and organised. A lot of useful information that can be applied to automotive mechanics in general. Great job!
Very precise and professional tutorial. Thank You!
This was a really great video these how to car Guy videos are better than almost anybody. My motor worked except that it was spinning but not turning the shaft. It turned out that the Teflon gear inside the motor had gotten stripped. I found one on eBay for $20. I replaced the gear inside the motor and everything works now thanks to this video! Except for the Minor details omitted this video is better than almost anyone else!
My bonnet switch was clogged with debris - now wipers working fine - thanks for the help.
Excellent instructions This guys youtube account should be printed in all Mercedes Hand Books!!!!
Great Bro!! You helped me. Thanks. In my case, all did works before I changed the hood, after few day I want use windscreen wiper but don't works nothing, the hood was closed, I checked rele and fuse they were work, motor too. I been begin to crazy. At finally, watching your video in the part that you use screwdriver to simulate the hood close. I had the illumination, so I prove to do the same thing and everything come back to work. The closures in the hood don't doing good contact so it seemed how the hood was open so nothing it works
I am glad I inspire you :)
Many thanks for helping troubleshooting this issue with the great content
I didnt know about the bonnet switch, saved me..thought the wipers were bad thanks
You're welcome
Thank you for this great comprehensive video
Many thanks for helping
I like your English & Video is great too😊
Thank you! 😃
Great perfect lesson! Thanks a lot!
This video was really good except some little details were missed. There are some washers and rubber bushing and rubber dams around the edges that were not covered at all. It wouldn't have lengthened the video by more than one minute to have included those. I found it I needed to add a lock washer to the motor shaft where the 13 mm nut holds it to the wiper assembly. I am still unsure where the big rubber washer went but it doesn't seem to be that important.
Just came home to an undercharged battery, recharged it and after getting car started found wipers don't work after turning switch. Completely dead. Going to trouble shoot with your guide. Great work. Thanks. By the way, my window washer is not working from before, anyway to troubleshoot it? Apparently there's no fuse??
Bravo it's an perfect explanation thank you
Selam friend
When I press the wiper arm, it sprays water and wipes, but it does not work in 1,2,3, positions. I removed the cable of the rain sensor, the result is still the same. Fuses and relays are OK. I changed my arm. Could it be from the engine?
How many volts should the wire have to change the speed?
Very good information, make it like u, and works! thx!!!
Nice
Thanks for the explanation! I recognize the sound that I experience after 3:17. My question, where does the sound come from? Then I hopefully can resolve the issue!
Great video very informative!!
awssome ....thx so much!
good informative information thanks
Great video. Too bad my front is working but the rear doesn't :) I suppose it should be similar in terms of testing the relay and the motor? I did checked the fuses. Thank you!
When I turn the wipers off they stop in the upright position.
Can you do a video on the fuel cap actuator won’t lock how to replace Mercedes c240 2005 4matic
Thanks for the help.
I made all the test and the motor works but when I test pin 1 and pin 2 which is the switch I did not get the 12 volts . I suspect my problem is the multi switch . Please give any other suggestions thank you !
Thank you so much for your video guide.
Glad it was helpful!
Hello, what exactly is the problem? The wipers in my car stay in the middle when I turn them off. Is the problem the fuse or the wiper motor?
Thanks for the video, currently stuck checking the wiper relay (Q) not getting a response. Unsure if motor faulty or multimeter not sufficient! Any suggestions?
Thank you so much for this video!! Very helpful!!
You're welcome
@@doit_vehicles On my w203 left arm work, right not work. Can you tell me what is the problem? Thanks
Does each side have a different motor? Watching your video it appears one motor operates both. In my case only the passenger side motor is not working.
Aldo, what is the “bonnet” that some people mentioned?
It's only one motor . Bonnet / under the hood 🤔
If applied 12v on the brown and green connector and wipers doesnt move does that mean the wiper motor is bad?
if the motor doesn't seem like it wants to spin , yes
Well presented
Very, very good tutorial ¡Bravo!
I am glad that you liked it
@@doit_vehicles Very proffesional, i am looking for some information to try to resolve my problem with the windshield wiper that star runnig when i push the combinated switch only to turn signal switch and then dont stop, stays running. To turn it off y must to stop the car, shutdown the engine, go out the vehicle and push down, around 1cmm, the wisper, then i can start again and the wispers dont move, till next turn signal light!!! ¿Any idea?
Hi i did everythig u did and the motor works when i jump IT and i change the swich relay but stil not working hjelp pls
Does the switch relay get power ?
doit_vehicles hi IT works now thank u very much
Hi it was fues and it works now thank u very much but My esp is on sadenly with it and tail lights er behaiv wierd is IT the break swich or ground problem thank u again for your time
hey can you show to how to replace the tailgate motor. Mine is locked and i can open only with key. thanks!
Any idea how to calibrate wipers? Mine hits bottom plastic and driver side pillar!
it's all about removing the cover and reposition them until they move corectly
interesting
My problem is that stop in the middle not all the way to the end. Maybe has another sensor??
The motor is not connected to the blades's arm , or maybe is spining or is decentered ?
doit_vehicles I will check the motor connection
Hey my wipers work normally but when I stop them they stuck middle
Of the windshield
What I have to do?
difficult task without a wire diagram , I would just reposition them manually
@@doit_vehicles yeah I did it and it worked thanks
Ești Român?
30 and 87 12volt give to realy wipers not on
12 volts to the motor ?
Its NICE TO HAVE MUSLIMS HELPING things? INSTEAD OF BLOWING UP THINGS!
Do not be sarcastic we need to respect each other