Plotter Update 2023 | Tips and Tricks

[@jaredwins155]

Thank you so much for this video Kevin. I have a Jag plotter on order and have been binging your videos to make sure I get it running well ASAP. Your trick with the 3m Exterior tape layered with Gorilla tape is genius. The part showing a cutout with not enough force, and how to roll the edge of the tint to not waste the pattern is so helpful.

[@BrayoTintsAndWraps]

thank you Kev! You always do a good job thoroughly explaining.
I bought a few back up blades on amazon just in case the last one that came with the machine goes bad. The blades at plotter depot are just too darn expensive. Also, I notice recently after turning on my plotter that the words on the screen were not showing at all and upon resetting, they would show as scrambled up, dang, I haven't even had the machine for more than 3 full months.

[@plotterdepot]

Please reach out to customer support. We can send you a new led panel. It's an easy swap.

[@TenguTone]

Any plans to make set up and or tips/tricks for PPF installers? I deal with bunching up a lot! Especially when cutting larger panels. Thanks.

[@j-money]

Workhorse 2 VS TITAN 2? What are your thoughts?

[@IFFMegaStore]

We are trying to communicate with you through the website. I do not know if you received the request or not. Is it possible to get the email?

[@RubenGarcia-in3tt]

Loading the film is it clear up or down?

[@swpboah]

You cut on the tint side so down.

[@meadalemi527]

What’s your socials?