Why This Print Fail?
Vložit
- čas přidán 5. 09. 2024
- Why This Print Fail? #Layer shifting #Ladder effect #Reasons #Solution
Explanation on ladder effect, layer shifting for 3d printing failure.
Reasons and solutions to solver layer shifting
#3D print fail
#Layer shifting
#Ladder effect
Very informative video, thank you for taking the time to film and upload it.
I just want to say this video was excellent! I wish more support videos were as concise, well illustrated and thorough as this video! I feel this should have many more views than it does!
Very underrated video but has heaps of very useful info! Must watch for new comers
A mask I was making shifted a full 10mm and then finished printing flawlessly.
Belts are tight. It was a 26 hr print on Ender 3.
Thank you
could this be caused by extra strain on the motors because of too-tight belts?
Qma Galadriel channel just come back to visit your channel :)
Thanks for support
@@gravity-less3dprinting624 Welcome to come to visit my channel:)
I am having these issue just on the y axis, trying to solve it right now.
Good luck, my friend🙂👍
Try going into your firmware settings and lower your “y” axis speed. That is if you have checked belt tension and pulley already.
Did you solve it? I have the same problem.
@@jefferylittleton1005 I solved all of my issues. Ended up being the crap drivers on the 4.2.2 board. Upgrades to a 4.2.7 with branded German made driver chips and all issues are gone.
@@ericvail6528 this is what I was thinking considering it started all at once without any mechanical changes, and that small prints are usually okay. Thanks for the advice!
No sound Feb 23
Come back support👍👍