Epever Tracer 2206an MPPT solar charge controller - two things that I don't like
Vložit
- čas přidán 13. 09. 2024
- I'm gonna show you how I use the Epever Tracer 2206an MPPT solar charge controller and I'll tell you two things that I don't like about it. Also some settings will be shown, accessories and building quality.
If you remow the protection film from the display, it will be easier to read.
Dude if you place the unit then you can see display with no problem
And remove the plastic protection of the display!!!
Hey dear I am facing power dropping issue in series connection. I have connected 340watt and 380watt solar panels in series to epever 40A mppt controller with 12v battery. It show power of one panel when I disconnect solar connector and reconnect, the mppt show both Panels. It’s hard to do this every morning. It was fine in winter but now summer starting and facing this issue. Using both panels form 2 months. after wire disconnect and reconnect the voltage jump from 33-36 to 75v. If something wrong with one solar panel then it should not work after replugging mc4 or solar wire in the mppt after that It work whole day but same issue next morning Both panels volts amps are little different. Tesla 34.51v maxpower 33.18v. Tesla amps 11.01amps maxpower 10.29amps.
To many panels try two
Does it have a cooling fan ? Does it get hot ?
Other fanless MPPTs can get almost hot to the touch if you are close to their peak power.
With the 100w solar panel the mppt doesn' t get hot for now. I ll check this in the summer and also when i ll connect a bigger solar panel. Thanks!
Mt50
Go get a mt50
Yesterday I could borrow an MT50 from someone and found out that one of my two mppt is not read by the MT50.
I could access one mppt and program it in user setting, but the other one doesn't communicate with the module as so I can not read/write from the MT50 to/from the mppt. :-(
Is there a way to reset this mppt TracerAN to reboot ?
To reset you could disconect it from the solar pannel and them from the batery. Wait couple of minutes and reconnect it.
@@testingeverything9748 tried that already a few times but still not connecting