Laser hardware sensor upgrade for Uniden detectors.
Vložit
- čas přidán 5. 05. 2024
- New wireless laser hardware update for the Uniden radar detectors. Comparative laser detection of an R7 with the new hardware installed, relative to the standard laser sensor of the Uniden detectors (R7 and R8) which don't have the wireless laser hardware module upgrade.
- Auta a dopravní prostředky
Will you do a how to video of what need to be soldered inside the r7.?
Great stuff. It will be interesting to see if filters will be needed for laser based cruise control systems in other cars.
This hardware was built for me by TMG. Therefore I believe it probably has all the necessary filtering built into the electronics signal processing.
@@mikefearn5213 Thanks for the post, the information, and all the hard work here! I am thoroughly enjoying your R7 International firmware too!
Great work! will it work with uniden R4 model as well?
Excellent addition. What would be an approx. range of detection?
Regards
Kevin
It's based upon a TMG hardware so I would expect it could pick up the laser gun well in excess of 1000m. Probably the longer the range the better it works as more air the beam has to travel through the more the beam is scattered.
wow... Nice. This is great where it's illegal to have laser jammers. Few questions. Will it work with R8? Will you be able to have multiple laser heads to use for trucks that are wider? And hopefully you will have a kit available with detail instructions.
Yes is should work with the R8 the same as it does with the R7. You can use multiple sensors and only needing the single wireless module installed in the detector.
can you help me make this configuration?
Hi, what type of sensor is it and where can I buy it to make it work?
Does it work with his firmware or do I have to get the international custom one from the forum?
This is a hardware upgrade that works with the on-board detectors laser hardware. Therefore can be pretty much installed in any detector which has a working laser sensor. Doesn't need a specific firmware upgrade to make it work. However with R7 156 international soon to be on release that'd be a no-brainer if you have an R7.
Does this support one or two modules?
You only need one module in the detector and that can work with multiple wireless units mounted in the car. I.e. with sensors mounted front and rear the detector will alert when either detectors the laser signal.