SolidWorks Sheet Metal Practice Exercises for Beginners - 1

SolidWorks Sheet Metal Practice Exercises for Beginners - 1. This tutorial shows how to create part in SolidWorks sheet metal step by step from scratch. SolidWorks sheet metal tools used in this tutorial are Base Flange, Edge Flange, Miter Flange, Extruded Cut, Unfold, Fold, Base Tab, Hole
#CADCAMTutorials #CADCAMSolidWorks #CADCAM3D
#CADTutorials #CADCAMMechanical

[@chaoukihassan8725]

your videos are so detailed thanks a lot

[@safakguney6912]

great. thanks :)

[@abdoismail3562]

Thank u so much man u helped me relearn sheet metal for my interview, hopefully i get it man

[@CADCAMTutorials]

You're welcome 😊 and all the best for interview.

[@bhattkishan9]

When I tried the first part of changing the bend radius, it was brining rebuild errors. I fixed it by changing the bend allowance to 0.5 K factor. It was already there in yours but for new installs, it might not be the case. ;-)

[@CADCAMTutorials]

Thanks for update.

[@husnibakhtiar502]

for solidworks recommendations which year is best for use?

[@ryanjirik7443]

Super helpful thank you

[@CADCAMTutorials]

You're welcome

[@hareeshyallaraddi7416]

U can do offset bend in place of sketched bend

[@alirehman2976]

Hi, Is there another way to make this 3d from straight 2d drawing using SKETCHED BEND tool in SHEET METAL?

[@lorenzoantonio9977]

for the sketch bend I can only get as close as the inner of the flange being 20.15mm from the top edge anyone else have this issue? have played around with the position options for the flange and the sketch bend

[@redcoatgaming3682]

Same here

[@Jsjoyaro]

Thank you sir

[@CADCAMTutorials]

You're welcome 😊

[@absolutegateway]

Hello sir, could you please tell me where do we get these kind of practice drawings

[@andrewlirio3816]

how about the K factoe

[@husnibakhtiar502]

what year did you use solidworks for? why it's so different from 2018

[@husnibakhtiar502]

Answer please.
for solidworks recommendations which year is best for use?

[@dannyloader9012]

@@husnibakhtiar502 use the latest.

[@Pandorarl]

2016

[@davethel86]

When i attempt to propagate the edge flanges, it doesn't work. It only works on 1 edge.

[@redcoatgaming3682]

Same problem

[@davethel86]

@redcoatgaming3682 I found that you have to make sure you're drawing the line on rear edge once normal to view is selected

[@davethel86]

@@redcoatgaming3682 you have to make sure that the lines you draw are connected to the rear after normal to is selected

[@automationguy9760]

Make it slow man