How To: Reverse Roll

In this video Ryan goes over the steps for the Reverse Roll install method.
Note from the installer: “I dropped the roll a little too hard here, which is why it bounced like that. It didn’t cause any issues, but try not to use too much force when dropping the roll.”

[@cajuncherie8447]

Thank you for taking the time to make this video and share. I learned several tips and tricks in a short time. Wish you would have shown what it looks like from the outside looking in.

[@MyHairyChin]

Clean install 👌

[@thetintstitute]

Thanks for the feedback!

[@alvink566]

Where can i get a squeegee like that to apply the tint?

[@JBIRD575]

Nice video neat corner trick...did u prep with blade ???

[@thetintstitute]

Thank you! Yes he prepped with a blade. Check out our latest video for our prep process.

[@joeleldersveld9634]

Nice install! What kind of card are you using for trimming the edges?

[@thetintstitute]

Thanks for watching! We use just any regular card but all work the same and you can use any kind you'd like to use

[@Solar-Busters]

You should trim both sides, top & bottom with release cuts after you slightly tack it down, don't go all the way so as to not have contamination & use one factory edge side as well, less cutting, less work

[@thetintstitute]

Thank you for sharing!

[@Solar-Busters]

Always address the re-roll off the cutting bar, the adhesive liner must be to the inside, thats extremely important

[@thetintstitute]

Thanks for the comment!

[@smartalecc5]

How do you get the liner to be on the person-side of the film? Do you re roll it the opposite way it’s wound on the factory spool? How to prevent it from being underneath the film. Thanks!

[@sao32]

He roll the opposite way!!

[@thetintstitute]

Hi Kevin, the reverse roll can get pretty confusing but the gentlemen below is correct. Thank you for watching!

[@Solar-Busters]

Always have to re-roll , Always ! That's the beginning of the trick itself , needs to be addressed for a new video

[@ElectricApe.]

@@thetintstitute
You literally titled the video How to back roll and proceeded to show almost nothing at all about back rolling.

[@Mad-Man84]

How you reverse roll and the liner was facing you i though reverse roll the liner should've been underneath right ​@thetintstitute

[@carpcarpenter2069]

Is this a machine shop? Noticed the starret granite surface plate

[@souldrummer818]

Call me stupid but can’t work out this reverse roll, sticky side is not against window can you explain please

[@jaser3312]

Wait, so the sticky side of the film is facing out, not on the window?

[@shadetree10000]

🔥🏆💰

[@sinaazadi5615]

Whats acceptable as far as seeing random dust particles under the film on a door that big? I hear its impossible to do a perfect tint install!

[@punkrockdadstv7674]

Dude👌👌👌

[@thetintstitute]

🤝 Thanks for watching!

[@shawnwilliams6638]

How much to charge for something like this?

[@thetintstitute]

We charge by the sq ft, anywhere from $6-$15 depending on the film and the other specifics of the job.