GM 10 Bolt 7.5 Ring and Pinion Setup Rear Axle Using Kent Moore Tools

[@Guyver50005]

pinion shim should equal 0.047 thou gauge went counter clockwise. time 4:07

[@JacqlynCharles]

Thanks for the Great hands on lesson. Pick up the same set at garage sale but missing parts and instructions is it possible to get a photo of the instruction sheet can not find online. Thanks

[@DELTRANIO99]

Great vid my 10 bolt makes a loud noise when accelerating ,,,Coasting and letting off the throttle its quiet

[@jondough4116]

Needs to be reshimmed a couple thousands usually on left side ring gear side worked for me..

[@enriquemartinez16]

Exceptional

[@obbyjep7597]

When a guy is changing parts wit the diff in the car is it nessasary to use a spreader or can you just get it so it will go together?

[@adamcorbett5069]

Will this kit work on a gm 7.2 ifs front diff ? Also would you share the installation instructions from that kit with me for specs ? I am purchasing that kit used and it doesn’t have any of the installation sheets

[@rodneyfama6399]

What is the kit number for the 77 gm 8.5 10 bolt. And 68 olds 12 bolt

[@HeathersHusband8387]

What size black impact socket did you use for the pinion shaft nut ????

[@eliashg2050]

32mm or 1.25"

[@merliclovis]

Thanks for the lesson! I currently have an 06 chevy1500. When i get off the throttle I can feel a slight grind feeling. It was worse before I replaced universal joint but still there. Any idea where i should look?

[@LakelandAutoMarine]

2wd or 4wd? Could be pinion bearings.

[@jimsperlakis5634]

Your Fowler dial gage is as cheap as they get. Don't matter the way you're going at it will probably only be able to get it within .002 anyway !

[@harrisjr9849]

What so you charge for 10bolt

[@codyeberhart8807]

What is the part number for the pinion bearing

[@hillarylevenworth8824]

A blind man might like that pattern but you could have made it much better than that!