700CC Yamaha Wave Venture Top End Teardown | Wave Runner 2 stroke

I diagnose and tear down the top end of one of my wave runners. This is a Yamaha wave venture wave runner with a a bad piston
Check out m brother's videos
czcams.com/users/thereistandvideos
Check out my Amazon page for items used in my videos
www.amazon.com/shop/cvsahara

[@travelguy1564]

Good job! Should run good after rebuild. One tip that I did on all my 700 Yamahas: I bought a $10 Oil Pump Block Off Plate and disconnected my oil injection system. Just pre-mix the oil and gas then you never have to worry about cylinders not getting lubed! Lookin forward to the final rebuild vid!

[@cvsahara]

Good advice. Definitely planning on that as well

[@jdlmon3]

Thank you for the video. I am also going to have to replace the pistons on my 95 wave runner III

[@moabwheeling]

Looks like a fun project . Looking forward to your next video .

[@yoyofd]

you have a video on re installing it . i want to see how you pushed the piston back in there without taking of the whole thing

[@yoyofd]

bro you don’t know how much time you save me . i have a locked motor and cudnt take the expansion pipe off i thought i had to take the screws on the bottom. but i just wiggle it and it’s off

[@anthonypino1131]

Can you help me with a cooling water flow diagram ?

[@Bod4Mee]

Did you ever get around to finishing it?

[@dlc8130]

Did you put it. Ack together?

[@dlc8130]

Have you finished this?