New Milling Machine Spindle - Part 3 - Turning The Bearing Housing

Machining the bearing housing for the spindle for two 32007 tapered roller bearings. External diameter 80mm, shoulder diameter 85mm, length 145mm.

[@stewartfrye]

Tape/bandage on finger was priceless, been there.

[@alimasoudian1890]

Hi Great video I have a question if we have something like this position of bearing then how is the lubrication with grease ?

[@mundodasmaquinas5071]

Muito bom seu projeto parabéns !! My Project homemade milling machine my channel

[@motolotnik8213]

Hello. Thank you for the great videos. Very good work. I have a question ... how will you later pull the bearing races out of the sockets? Regards

[@kvechannel]

I tried with screwdriver and worked. Is not too tight. But yes i forget to turn a bigger gap for puller. If the if the screwdriver hadn't worked, i would have made a puller with two clamps with sharp edges and a screw inside the two clamps that pushing the clamp edge between the race and housing

[@AdamMaszynotwor]

🦾🦾🦾

[@musicmaneman38]

What type of steel is that?
I have some 3" 4140cr I want to use.

[@kvechannel]

Is some kind of carbon steel but i dont know what is.. it has a bluish-gray color and is softer