All Fuel Oil Foundry Burner Atomizer - Can be used for a Kiln Burner, Oil Heater
Vložit
- čas přidán 18. 01. 2014
- Newly built all fuel burner assembly test on Kerosene. Excellent results without any additional air adjustments on the back end. Fitting on the end is for a hair dryer attachment to increase the air input which will increase the flame heat without increasing the fuel input.
- Věda a technologie
Hooked this baby up to my newly created Forge and it heated up hot enough to melt my aluminum in only 30 mins. and used very little oil. About 1/2 gallon to mext over 100 cans and made 3 1/2 ingots. Very pleased with the results so far. Will try to melt copper next!
I have one but i can only get it to light up when i have something covering the rear of the burner tube and it doesnt stay lit for very long. Any suggestions?
The only thing I can think of is the end where the fuel exits could be closed off too much or blocked with dirt. If you can open it a bit that may help. Also the air pressure from the compressor could be leaking out the back of the fuel supply tube inside of the brass fittings and not blowing out the front to force the fuel through the burner opening. Those areas should be checked.
Was it able to melt copper?
I haven't had a chance to try it again. Been busy with house re-modeling. My first furnace burned up and needed to build another one with better concrete so may be able to try it out in a couple weeks.
Thanks for the quick reply