How to tie down your Can-Am Maverick X3 to your Trailer

Sdílet
Vložit
  • čas přidán 6. 08. 2024
  • Here are a few different ways you can strap down your Can-Am Maverick X3 on your trailer. In general, here are a few rules:
    1. Do not compress the suspension if at all possible
    2. Straight line front-to-back is best
    3. Farthest out on the suspension near the wheel is best
    We used 1.5-inch SpeedStrap ratcheting tie downs with tie-back loops:
    speedstrap.com/product/1-5-x-...
  • Auta a dopravní prostředky

Komentáře • 10

  • @duneme
    @duneme Před 2 lety +1

    Looks good!
    Thank You Jon!
    (This is Mark in Elk Grove!)
    We are paying off another investment now but, I see the day where I’m back into it!
    (I know, crazy after what I have been through!)
    Liking these CanAms! I think I would do 2-seater! If I have to pack lighter I’ll pack lighter!

  • @Dustin_Curley
    @Dustin_Curley Před 2 lety +1

    Man, as I was watching I thought you were promoting the first method. I was like no no no! You know better. Then I kept watching. Lol. We use tire straps with E track, wife and I can get the rzr secured in about 4 min. Great video, showing why you don't do some of the crazy stuff I see on the road. 👍👍

    • @UTVGuide101
      @UTVGuide101  Před 2 lety +1

      Tire bonnets are best, but most people use straps.

  • @samuraicowboy9605
    @samuraicowboy9605 Před rokem

    Excellent video. With a top-notch machine like that, we wouldn't take any chances. Minimum 6 points of tie down, preferably 8 as you have 1 valuable asset on that trailer. 4, 1 to each tire, 1 forward straight, 1 back straight and a criss-cross from outer rear axle as seen in your helpful video. 2 sets of straps (8 total) are not too much to ask for a vehicle of that caliber.

  • @venyhernandez7717
    @venyhernandez7717 Před 2 lety +1

    Good video

  • @jakesutton9704
    @jakesutton9704 Před 2 lety +2

    What is your wheel offset and trailer size?

  • @ronshah2095
    @ronshah2095 Před 2 lety +1

    So... what method do you recommend...?

  • @bradking2550
    @bradking2550 Před 2 lety +1

    i use tire bonnets on my open trailer that i have etrack on. I just purchased a toy hauler and the way the D-rings are laid out the wheel bonnets will not work. later on this summer going to look at putting track in it. For the time being i am looking at using through the wheel straps, what is you opinion on this setup

    • @UTVGuide101
      @UTVGuide101  Před 2 lety

      Tire Bonnets work great and through the wheel is good too as long as you’re not rubbing on anything sharp.

  • @R3rolling
    @R3rolling Před rokem

    get tire mounts, straps, 100% better