Sometimes ya get lucky. Follow me as i walk you through how i fix non booting bally pinball computer MPU boards. It's not always this easy but sockets are always a great place to start.
Lots of good advices here in this video. Just one thing. Your’re blasting those through holes with that large solder tip. Try using a smaller one. Its well worth it.
Stern pinball boards are interchangeable with Bally's of that era and have a Red LED. If it doesnt boot this video was a quick guide. Lots of info on the web you can refer too. Hope you figure it our!
I'm working on a strikes and spares right now and it too had 4 flashes. I put left pressure to the lower left connector j4 on the mpu and it booted up. I removed each pin on it and sanded the black off each pin ok now.
Lots of good advices here in this video. Just one thing. Your’re blasting those through holes with that large solder tip. Try using a smaller one. Its well worth it.
nice video my guy
Really good info, BUT, do you think you can jerk the camera around and get it out of focus a little bit more.
Probably could!
At 1:50 you have your probe at "spot 38". What's that? It looks like it's touching pins 39 and 40 of U10. Please advise.
Bad Ass chip puller!
My Dolly Parton mpu has a red lamp instead of green, is that normal. Either way it's not coming on at all.
Stern pinball boards are interchangeable with Bally's of that era and have a Red LED. If it doesnt boot this video was a quick guide. Lots of info on the web you can refer too. Hope you figure it our!
Hello I have the led blinking 4 times
Google Bali MPU flashes four times and a lot of articles will come up. 4 flashes is almost there!
I'm working on a strikes and spares right now and it too had 4 flashes. I put left pressure to the lower left connector j4 on the mpu and it booted up. I removed each pin on it and sanded the black off each pin ok now.