How to replace front driver axle infiniti G37 G35 Q40 G25 Q50

How to replace front driver axle infiniti G37 G35 Q40 G25 Q50
Shop for Leds: bit.ly/38aLjnj
Hope you enjoyed the video don't forget to leave a LIKE and SUBSCRIBE also hit the BELL so you get a notification when new videos ARE POSTED!!!
Follow me on instagram:
Jules Mechanics official Page: bit.ly/2Dl9vl7
MY Car Page "VQFEDDY": bit.ly/35D6JJxr

[@flipmode00]

This has to be a blessing lol, I am about to do mine next week after the part come. Thank you

[@aaronbillings3250]

Thanks bud taking that boot off made all the difference in the world getting those 6 bolts off

[@flipmode00]

I forgot to mention dont forget to check your brake lines mine are rubbing with the lower control arm and deteriorating, This will be the third set that I will order. My next set will be the short and not the long braided line.

[@stevenzou3771]

dude ur the goat

[@bbg9458]

Where did you pry and hammer to get the back part out

[@nsbzel5957]

What the cv attached to can you remove that plate without losing fluid? The plate that attaches to the cv axle

[@josekuervo5666]

Yo man where can I find those hex screws? I keep finding cheap ones I need stronger ine

[@camfreeman5911]

12:02 what size is that

[@djandfam4868]

If you can mve your spinal a lil is that bad?

[@yoshioutt857]

How long did it take you do it?

[@Skumo]

What brand are those Axles?

[@user-gv1ff2hw1o]

By any chance do you know what are the wires that run under the cv axle? My axle broke and spliced into a wire that runs under it .

[@edisonlayman]

It’s for your wheel speed or abs

[@luciddy527]

same

[@G37keith]

W vid

[@Krypton999]

thank u bruh

[@ricardobarahona8824]

What size are those bolts

[@Teacoke9]

How do I take the front axle out of the transmission the bolts are broken off in it drivers side

[@LegitMods4u]

Ever figured this out

[@kentrellhines4174]

So I have a g37x sedan do have a site where I can order the axles

[@vegas2023]

Rock auto

[@Teacoke9]

Can I pull that part out of the transmission the bolts are broken inside of it

[@vqfelix]

What did u end up doing?

[@djandfam4868]

After u put everything bck together

[@Renault-v10]

What do i do if those 10mm are stripped? I tried the extractor and it doesnt fit

[@JulesMechanics]

They have thinner extractors make it fit turn slow might have to use fire 🔥

[@camfreeman5911]

12.02 what size is that

[@pmsrks]

what years is this for

[@dudewiththeprix8175]

You should’ve showed us how you tightened them cause the only way I could was using a baby ratchet and doing 3-6 clicks at a time😂 not fun doing cv axles on these

[@bryansandoval3307]

Just did mine and no cap shit suckkssss 😂😂

[@OleBoyyy15]

I am NOT looking forward to doing mine 😭😂

[@tomzphone]

Way to much of unnecessary work. I never removed half of this stuff you did. And if you didn't replace the shaft with an original Nissan shaft, but an aftermarket, you will be doing this job again in less than a year. Should have only replaced the boot..

[@dannyhardesty6137]

Do I need to regrease it before adding the new boot?

[@tomzphone]

because my car is lowered, I seem to damage these boots more often. I never completely clean them out first, but do put new grease inside the boot. @@dannyhardesty6137

[@dannyhardesty6137]

With all do respect, I think this was a much needed video for pulling out the CV Axle, those 6 10mm are almost impossible to remove without a impact.

[@ynegra0481]

I wont say that, I replace mine with aftermarket parts and 2 years after no issues so far it depend t what kind of aftermarket part.

[@OleBoyyy15]

@@ynegra0481brand?

[@JMRRebuilders]

Absolutely a horrible design.

[@mauricesj66]

You remove way more shit than you needed to😅

[@JulesMechanics]

Show me better