I'm surprised that the spindle nose wasn't polished up on the outside ( 6.17 ), I know it's only cosmetic, but it would finish of the job. I'm also surprised that the bearings were just slide on the spindle ( 5.46 ), I thought that they'd be a press fit.
No good practices seen here. Cleanliness is the most important thing when working with those utterly expensive spindlebearings. Every hobbyist would do it as shown, for a professional spindle repair this is nuts. Sorry
Esta bien. Lo bueno es hacerle pruebas de spm al husillo en la maquina ya con carga. Y verificar vibraciones asi como clampeo del drawbar.
This is a great video. Thank you for sharing.
สวยงามครับ
Não foi feito balanceamento? e a limpeza do fucinho do fuso????
Pregunta bareros ceramics se agrega grasa
Are you from which country?
Spindle rate
I'm surprised that the spindle nose wasn't polished up on the outside ( 6.17 ), I know it's only cosmetic, but it would finish of the job. I'm also surprised that the bearings were just slide on the spindle ( 5.46 ), I thought that they'd be a press fit.
Heated probably
The bearing is heated, look he is using heat resistant gloves
No good practices seen here.
Cleanliness is the most important thing when working with those utterly expensive spindlebearings.
Every hobbyist would do it as shown, for a professional spindle repair this is nuts. Sorry
You do not know if the spindle was assembled in a clean room or not.
@@Terminator550 I don't want to sound arrogant, but it ain't.
If you have worked in a ISO certified cleanroom, you can tell a little bit.
Bi đâu 7c hả