How to control valve calibration and maintenance
Vložit
- čas přidán 8. 09. 2024
- CONTROL VALVE POSITIONER WORKING PRINCIPLE
#controlvalve #controlvalvecalibration #controlvalveparts
A valve Positioner is a device used to increase or decrease the air load pressure driving the actuator until the valve’s stem reaches a “POSITION” balanced to the output SIGNAL from the process variable instrument controller.
Valve positioners are used on controlling valves where accurate and rapid control is required without error or hysterises.
Positioners are generally mounted on the side-yoke or top casing of the pneumatic actuator for linear sliding stem control valves, and at/near the end-of-shaft for rotary control vales. For either basic design type, “mechanical feedback linkage” connected directly to the valve’s stem provides feedback to controller. The process controller tells the positioner to “change” position; the feedback linkage reports back to the positioner confirming that a change has occurred and gives a “sense” of the magnitude of the change in position.
👌
Nice content, thanks for sharing.
Thanks dear
Bahut badhya sir isi tarah ka video banaiye
All information is good.
But I need main function in written.
Please write it only main function.
Thanks
Very very nice👍
Sir calibration kr ke dikhaiye please with the adjustment of zero and spane setting
Nice
Nice sir but esi positioner ka calibration ka video bhi banayiye sir
provide an english subtitle sir..and it will be very good toturial.
Thank u
R/s my actuator does not got close 100℅ on 20mamp what is the problem from actuator valve or need caliberation
LCV agar 60% se jyada open nhi ho rha h to kya krenge
Wire ke canntion bar me janakari dene hey
I to p kam nahi karga toh kaisa pata chalaga sir
see.Aap.Apna.Contect.N.Den