Programming tips for SAAS Muscle Digital gauges
Vložit
- čas přidán 29. 08. 2024
- Here's another quick one-take where we show you how to exit the "Demonstration" mode of our SAAS Muscle Digital Series gauges.
It's possible to place a digital gauge into "Demonstration" mode via normal programming simply by holding down the programming button a little too long during the gauge setup.
"Demonstration" mode places the gauge into a "loop" where the display cycles up and down the complete range, and periodically sounds the warning beep. This can create the impression that the gauge is at fault as it is not possible to exit this mode via normal setup steps, or by cycling the power supply.
Luckily it's a simple fix!
Follow through our quick one-take to see just how easy it is to place the mode in, and more importantly, OUT, of Demonstration mode.
If you're still having difficulty exiting the mode, log on to our website www.shopsaas.com and get in contact with us - but I reckon this little video guide will pretty much do the trick!
Thanks again for watching!
The ShopSAAS Team
I was about to throw my whole car in the bin cause of this, cheers 😂
how do i change colours?
I've got a SAAS Trax boost/EGT gauge and the LED segmented display is far to bright at night, is there a fix for this??? The analogue boost part is fine, and both do dim when the park and or head lights are turned on.
Otherwise, it's a good bit of gear. Just way to bright at night.
Would you recommend a mechanical or digital gauge for oil temp and pressure gauges? Especially for a beginner / easy set up
Hi i got a digital tacho and it fluctuates 2000 to 3000rpm more at idle. Its set to 8 for 8 cylinders and if you pull the coil lead off and crank it the gauge shows 1400rpm and can tell you its nowhere near that. Have you got any thoughts. I have put a 10k 1/5w resistor in and made no difference. Could a faulty coil cause this? Bosch electronic ignition.
I really like the look of your speedometers. You say it will read a hall effect signal. I have built an ev, my fardriver controller sends a hall signal from a wire to give a speed pulse for a display. Would this work with your display?
Hi Tori - so long as your signal is a square wave, it may prove to be ok. If you submit an enquiry through www.shopsaas.com/form/contact-us/ our gauge tech Rob can discuss with you.
Cheers The ShopSAAS Team
Can these also show the pressure in bar instead of psi?
looking to get a few of this in my mazda bravo, what do i need and how much senders do i need to get it going
G'day @TRDieselPerformance - the gauges come with senders but adaptors may be needed depending on gauges selected, engine, model year etc. Submit an enquiry through our website www.shopsaas.com and include a few more details about your gauges/vehicle and we can respond accordingly.
@@saasautomotive6997 you guys are awesome, thanks i Will be sending you a message
update, i alrady got my gauges and wverything, i guess i will be installing tomorrow, i just want to know i you guys can lead me to choose the size of the radiator hose water temp adaptor, should it be a 38mm or a 35mm, i dont know wich one works with the sensor you provided
thanks in advance@@saasautomotive6997
Why make it like this lol
these look cool but are absolutely unresponsive and inaccurate. if you are just going for looks go for it