Video není dostupné.
Omlouváme se.
I put Uni-Shine LED headlights with halo ring on my Jeep CJ-7!
Vložit
- čas přidán 26. 12. 2022
- UniShine 7" LED headlamp set - amzn.to/3PT6cs2
Products and tools I use and recommend (Get 10% off Vevor products with code VVS10)
Vevor MIG 130 flux core welder - s.zbanx.com/r/...
Vevor Cut 50 Plasma cutter s.zbanx.com/r/...
Vevor welding table - s.zbanx.com/r/...
Vevor diesel heater - s.zbanx.com/r/...
Bearings - amzn.to/3HZhwAJ
1/4" closed cell foam - amzn.to/40tk9lr
Yeswelder welding hood - amzn.to/3VedwA5
Battery powered button light - amzn.to/3Y4BwYo
Leather welding apron - amzn.to/3tK3lrd
INE flux core welding wire - amzn.to/3VbhEB0
Creality Ender 3 3D Printer - amzn.to/3UmN46B
Duramic TPU filament - amzn.to/3KgTL8Q
Overture PLA Plus filament - amzn.to/3WD4jCz
Connecting up the turn signals and parking lights to the headlights really was easy. The new headlights has a pigtail with the 3 wire connector that plugs into the vehicles headlight connectors and there's also two smaller wires with spade connectors as well. Included in the package are 4 long wires with spade connectors on each end, they plug into the two small wires at the headlights and run to the turn signal lamp housing, which has 3 wires, ground, hot for parking and hot for turn. Just splice the two wires coming from the headlights into them and you're good to go. It really is that simple.
I installed these on My 85 cj7 but only the ring works not my acual headlight what do you think I should check to make them work again
Thanks for the video. I'm about to order some off Amazon from my CJ5 right now. I hope they're still holding up?
They're still working fine. However, my Jeep has only been on the road for a few weeks now, so they really haven't been put to any great test.
Nice
😀
How did you attach them?
I used the stock hardware with some minor adjustments.
@@3rdpigdo I need to have led parking/blinkers for these to work?
There’s a better option 😮
Well whatever you do, be sure not to share it!