Installing Headers on my E46 | First Engine Mods for the Drift Wagon
Vložit
- čas přidán 15. 06. 2023
- Installing Headers on my E46 | First Engine Mods for the Drift Wagon
Welcome to the channel. Please consider subscribing. In this episode of my life I endure the EXHAUSTING ordeal that is installing headers on the BMW station wagon drift car. Enjoy.
My info:
www.gripandslipmotorsports.com/
INSTAGRAM @el_wagone / el__wagone
INSTAGRAM @GRIPSLIPSHOP / gripslipshop - Auta a dopravní prostředky
keep it up!!! Car sounds great
Thank you!!
Cat sounds great bro, these headers have been around a long time and have always been problematic. That rear section especially never lines up with the factory flanges. It's a tough job but you got through it💪
Thanks a ton man. Yeah it was a terrible job and I feel like its only finished for now. Thank you for watching and letting me know.
i ordered ebay headers for my 01 330ci few years ago.. had my engine out anyways. threw them on, dropped the engine in and the last o2 bung is too long and wrong angle. swapped my factory ones back in, ebay headers still hanging out in the garage lol atleast till im commited to do a o2 and secondary air pump delete with the proper tune. anyways thanks good video, good info
I seen on Nate’s garage he cut and grounded out some space between each port on the header mount plate basically giving it a little flex for install . Im going to tackle this soon and do the same
I may do that on the next set for the b30 engine im working on.
Nice job papito. Im about to bring the old 93 SI Honda back lol.
Oh hellllllllll yeah!!!!!
Nice video, where I get headers like that for my bmw 325i 2004 4 doors e46, and what 02 I have to connect, the top or the bottom.
About to start installing mine today hopefully it goes well about to cut the 02 sensors down on the headers,
Heck yeah man. Good luck its not easy but its basically necessary on these cars.
Broo.. where can I score uel headers for my e46.. I need the subi.. sound
Hii Link tho Headers plz thx
Where you get the tie rods
SLR speed.
& what gaskets did you use??
Just used the factory gaskets and removed the heat shields.
hey do you have a link for these headers very hard to find
This should be it.
www.protuninglab.com/99bmwe46396e.html
@@DriftSanti you're a wizard thank you
Have you noticed any performance improvements since the install? Thanks for the great video btw
Thank you. I have actually. My car is high miles so I am sure my cats were well clogged. This freed up the car a bit so revs climb much nicer. Idk about actual power but doesnt feel choked out. Also sound. I been drifting a long time but never had a drift car I could actually hear. Lol.
@@DriftSanti thanks for the reply. The sound adds a lot of character to a car.