VW Transporter T6 diesel Tank Tap and Water Tank install How To !!

Sdílet
Vložit
  • čas přidán 27. 05. 2020
  • Hi and welcome in this video i'm going to be fitting a VW T6 watertank under the van then i am going to remove the fuel tank to install chinese diesel heater fuel feed line to the tank this is part 1 heater install under the van coming soon.
    Thanks for watching !!
    www.bensound.com" or "Royalty Free Music from Bensound"
    #vanlife #chinesedieselheater
  • Jak na to + styl

Komentáře • 21

  • @sionilar
    @sionilar Před měsícem +1

    Thanks for these videos, Paul. On my third van, and this was gret prep for a newer AdBlue van. Cheers!

  • @interestedpart2650
    @interestedpart2650 Před rokem +1

    Excellent tanx

  • @davidburns5027
    @davidburns5027 Před 3 lety +1

    So clean under your van! Mine is a 13 plate and it's filthy!

    • @paulshideout9056
      @paulshideout9056  Před 3 lety

      Thanks David I'm sure it will get dirty if I use it ! Lol

  • @christiangoller9280
    @christiangoller9280 Před 4 lety

    Hi, great vid! Quick question, is there a designated place for the end of the fuel pipe in the sender unit? Looks like theres a slot on for t5 - same for t6? Thanks!

    • @paulshideout9056
      @paulshideout9056  Před 4 lety +1

      Thanks christian goller mine just went straight down at the side of the sender not the same as t5.
      Thanks

  • @drewmce
    @drewmce Před 3 lety +2

    Hey Paul, great video mate thanks!
    Did you buy that fuel line pipe you fed down into the tank? I'd like to get one for when I install. Got a link?
    Thanks again

    • @paulshideout9056
      @paulshideout9056  Před 3 lety +1

      Hi thanks this looks the same as mine good luck with the conversion www.ebay.co.uk/itm/49cm-Fuel-Tank-Sender-Stand-Pipe-Pick-Up-Clip-Hose-For-Eberspacher-Diesel-Heater-/124512466693?_trksid=p2349624.m46890.l49292

  • @dieselbushcraft1299
    @dieselbushcraft1299 Před 3 lety +1

    Interesting to see the diesel feed for the heater. Did it cause any problems with the AdBlu? Got to admit that I’m apprehensive about this job.

    • @paulshideout9056
      @paulshideout9056  Před 3 lety +1

      Hi when you fit the pipe you don't have to touch the Adblu system hardest part is getting the filler neck back in place ! Make sure you tank is very low on fuel also if you was local I would offer my help. But good luck !

    • @dieselbushcraft1299
      @dieselbushcraft1299 Před 3 lety

      @@paulshideout9056 thanks for the advice Paul it’s appreciated. We are a few hundred miles away here in the land of the whippet and flat caps but cheers.

  • @fnordpole
    @fnordpole Před 3 lety +1

    Hi Paul, thank you for making this detailed video! I will soon remove the tank of my T6 and install a sender for the heater as you did. Where is that red button that you mentioned you forgot to press so the gauge did not work afterwards? It's not on top of the thingy you can see at 19:57 in the video, or is it? Can you see that red button somewhere in the video?

    • @paulshideout9056
      @paulshideout9056  Před 3 lety +1

      Hi thanks yes that red button is on the electrical connector it locks it in, don't forget also make sure to plug the new pipe if you don't fit the heater straight away or it will leak diesel don't forget to subscribe if you want to and good luck !

    • @fnordpole
      @fnordpole Před 3 lety +1

      @@paulshideout9056 Ah, I see! Will take care of it. Thank you! :)

    • @caidenkhari5756
      @caidenkhari5756 Před 3 lety

      pro tip : watch series at flixzone. I've been using them for watching a lot of movies during the lockdown.

  • @lovtwotravel
    @lovtwotravel Před 3 lety +1

    Great video I was just wondering if you had the link for the watertank as I’d like to purchase one

    • @paulshideout9056
      @paulshideout9056  Před 3 lety +1

      Hi and thanks I got in from ebay but private seller this is the same I have only found 1 company selling this type it finally filled up now it's great ! www.ebay.co.uk/itm/132979302137

    • @lovtwotravel
      @lovtwotravel Před 3 lety +1

      @@paulshideout9056 Thank you for the info I’m definitely going to grab one and put one in

  • @sh90xs
    @sh90xs Před 3 lety +1

    Hi, could you have just cut a tee into the main diesel line, as that's what I'm thinking of doing

    • @paulshideout9056
      @paulshideout9056  Před 3 lety

      Hi I'm afraid you cannot do that with a pressured system i wouldn't try it, its not too bad to lower The tank.thanks and good luck