@@ourentrepreneurlife3348 thanks bud I will drill the back lock and check it out. I looked down into the prize shoot and didn't see a hole for a sensor. I'll look in through the back. Also I think I'm going to attempt to install new led lights.
I have a stacker, but when I win minor or major price it doesn't let me choose an item. The button lights up but when I push the button nothing gets selected. What can the problem be?
You you can definitely replace just one LED, all you have to do is confirm the orientation. Then desolate the old one using a solder iron and a solder sucker or solder mesh. Once ready install the new one in the existing holes with the correct orientation. Add a little bit of flux and solder the new one in place.
Great Video, really helpfull :)
Where do you get the replacement led squares from?
Where can I buy the led boards?
hello, i have one cube on my lower board that remains on. any suggetions?
It’s most likely something wrong with a chip on the board. I would remove and inspect the board.
My stacker machine is throwing an error code 5. It is the prize sensor. Where is the sensor located?
It’s located in the prize shoot. You’ll need to access it from the back.
@@ourentrepreneurlife3348 thanks bud I will drill the back lock and check it out. I looked down into the prize shoot and didn't see a hole for a sensor. I'll look in through the back. Also I think I'm going to attempt to install new led lights.
My machine just has 1 light that doesn’t turn on at all how should I fix it?
You should be able to fix it just like I explained in the video. Typically the lights just burn out.
@@ourentrepreneurlife3348 I just bought the machine and know nothing about it could you help me?
I have a stacker, but when I win minor or major price it doesn't let me choose an item. The button lights up but when I push the button nothing gets selected. What can the problem be?
I would suggest to check the wiring to the button first. That is most likely the issue.
Ugh great! I have experience and just bought it for my son's birthday. I found the manual online so I'm going to test it tomorrow morning.
I have 1 block missing can I soldier it on how do I attach it on
The resistor
You you can definitely replace just one LED, all you have to do is confirm the orientation. Then desolate the old one using a solder iron and a solder sucker or solder mesh. Once ready install the new one in the existing holes with the correct orientation. Add a little bit of flux and solder the new one in place.
Prize selection button not working on mine, any ideas?
Most likely cause is the wires on the bottom are unplugged or the micro switch is no longer attached to the button.
Where do you buy the LEDs
eBay or Suzo Happ
@@ourentrepreneurlife3348 how do u fix error 5?