Goof-off is crap. I used a whole bottle and didn't work at all for me on just one section. Get De-Solv-It Contractors' Solvent. After pealing off as much of the mats as you can 1) Spay on solvent and wait for 5 min or more. I sprayed one section while scraping another 2) Plastic scrape while wiping scraper with paper towel to get 80% of adhesive 3) Spray same section again and go to next section that has been soaking 4) Go back and get remaining 20% use a razor scraper (it will be fine) 5) Finish spots with a Magic Eraser 6) Wash off remaining chemicals with plenty of soap (simple green) and water
Great job on the instructions. Thanks
I used hot poddy knife that I rounded the corners with and wash the glue with regular gas . Was using every possible thing but gas worked the best .
what is the pattern called on these traction mats?
Goof-off is crap. I used a whole bottle and didn't work at all for me on just one section. Get De-Solv-It Contractors' Solvent.
After pealing off as much of the mats as you can
1) Spay on solvent and wait for 5 min or more. I sprayed one section while scraping another
2) Plastic scrape while wiping scraper with paper towel to get 80% of adhesive
3) Spray same section again and go to next section that has been soaking
4) Go back and get remaining 20% use a razor scraper (it will be fine)
5) Finish spots with a Magic Eraser
6) Wash off remaining chemicals with plenty of soap (simple green) and water
it really is, especially for adhesives, there is too much oil in it. It is better for other types or car badges.
good job thanks for this video +++
Gasoline worked well as an adhesive remover
Holy Christ man, a little energy? Guy puts me to sleep
.знам