Correct mainboard connections for the CTC Prusa i3 Pro B 3D Printer
Vložit
- čas přidán 13. 03. 2018
- Because the manual which came with this diy 3d printer kit is a mess, I made this short video about which connection goes where on the main board. If I had this list before I started building, it would have saved me a lot of time.
This video is the first in a series of videos about this 3D Printer. If you like to see more, consider subscribing to my channel; that would be awesome!
This is the list of components which go on the mainboard:
1. Power
2. Heating bed
4. Extruder heater
11. Filament feeder motor
12. Z-Axis motor (up/down) left
16. Z-Axis motor (up/down) right
13. Y-Axis motor (forward/backward)
14. X-Axis motor (left/right)
15.1. Fan for extruder
15.3. Fan for PCB
17. Z-Axis stopper switch
18. Y-Axis stopper switch
19. X-Axis stopper switch
20. LCD Connection EXP1
21. LCD Connection EXP2
22. Temperature sensor extruder
24. Temperature sensor heating bed - Věda a technologie
Amazing, thank you. Mine has been stood around for years unfinished. Now the fun starts.
Thank you so much! This helped me a lot =)
nice video. hope to see some nice 3D printing soon :)
Where can I buy this exact motherboard? Mine is busted
I have a Prusa i3 Pro B and am using Cura 4.5 software with as setting of Prusa I3 MK2 and I'm not happy with the print outs. What software are you using.
I was not happy with the results of Slic3r. So I went for Repetier Host with CuraEngine as slicer.
Did I miss an episode where you bought and assembled it?
Haha. No. I assembled it without filming it, because the printer is a bit too large for my workbench. Also, so many people have already filmed it, that my video would not be very helpful. I will do a video about the strange things I encountered while building and some tips and tricks which may save other people some time during assembly.
Ha! When can i order on Bas-shapes?
LCD , SV1.........ON BOARD, WHERE GO ON LCD :(EXP1 , EXP2).....??
EXP1 is the top one, and EXP2 is the bottom one on the LCD-board.
Bas van der Sluis thanks, My question is, lcd is for exp1 or exp2?.....thanks Again
EXP1 is LCD, EXP2 is the SD-card slot.