Step By Step How To Start Your Nitro Engine If It Won't Start!
Vložit
- čas přidán 20. 08. 2024
- I hope this helps some of you!
My Amazon Wish List www.amazon.co....
Join this channel to get access to perks:
/ @haggardrc
You can help me make better content by donating Via PayPal as a gift to RustySkullProductions@hotmail.com!
Or you can use this link: paypal.me/Rust...
Every penny that is donated will go into making good quality videos for all my loyal subscribers!
Many thanks to you all :)
#Nitro #RCCars #NitroRC
I have found this video very helpful and I just have to put this step by step into practice. I have a long way to go in getting my new monster truck started for the first time.
Have fun 🤘🏻
Me too, still struggling with three of the blighters, to even get one to start!
EXPERIENCED😊
Nitro videos help wanted video you all way do nice job showing how to help people learn. Nitro thank you for making me videos 📹💯🔧
hello i have a 1999 toyota celika gt maybe older idk it was my dads rc car back in the day. Im trying to start it after like 6 years we hade sarted it. now it wont start whatever i do thank god i found this video that might help me make it run again the only problem i think it causes it to not start is the fuel bc it was sitting so many years in a garage maybe it wont have much power idk. I will try the things you sayd to do hopefully it will start?. i will update you if it will start!!!!😁
Enjoy all your videos, and picked up a few tips from this one too. Any chance of a video about tuning these engines? I can never get mine to restart, after refilling the tank, unless I leave it for 10-15 minutes. Even then it’s a struggle. Use a roto starter.
Thank you for doing this video.... I have a working glow plug and fully charged glow starter.... I also tried the easy start method but it still won't start... I was worried is was somthing internal like crank shaft or cylinder head😢.
I did heat engine with a hair dryer. Last time I used it(working) it was off the ground and it sped up turning wheels into pizza cutters... I lost exauste screws and gasket(I replace with new ones) my carnage still won't start. I will test for low compression later. After that I'm guessing a new engine is on the books😢
If it revs up like that then the throttle is stuck open.
the do exsist compression tester but its not like with big engine. de compression is not the same every time
it depends on how fast you turn the engine over and the heat that in the engine is different the compression is not the same ,
Maybe one - way bearings as well?
Well I guess that goes without saying too huh?
Well yeah that’s not really an engine issue is it 🤷🏻♂️
Still having trouble getting my brand new nitro rc started. I checked all these steps and nothing had seemed to work. I just can’t figure out what I’m doing wrong and I’m almost ready to throw it out.
Fuel gets into carb as I can visually see it going in. I pull the starter quick shirt burst and nothing ever sounds like it’s gonna start. I just keep pulling and fuel just keep spitting out the exhaust with no sounds of it wanting to start.
I’ve gone over all these tips step by step and just can’t figure it out.
Have you check the glow plug?
@@HaggardRC I did and it glows bright orange. I didn’t think it could be that since it’s brand new and it glows bright orange
There is actualy compresion tester for nitro rc car engine , but its ower 60 quid
Great video very helpful. Quick question can you tell me why fuel is coming from the side of the engine or from the exhaust from the engine 🤔
Where on the side is it coming from? It might be from under the head if it’s not sealing properly
Thanks for getting back to me it's not from the head I think it's from the exhaust there a black ring I think it's coming from there that's why I asked the question I'm new to the game but loving it.
What engine is it? It’s normal for some to come from there because it’s only held on by one or two springs. Some are bolts like on the T-15 for example but most others are a rubber seal and springs
I'm unsure on engine make i no it's a 21 nover rossi I think it a old truggy hong nor crx c1 if that make sense there it's two springs around the engine.
I live In the Caribbean so it's always hot here(like summer all year around basically ) should I still heat up my engines before I run them ?
Nah man it will be warm enough there it'll start fine without any heat.
This was a great detailed vid, thanks. I'm new to it use to drive full size Race Karts 2 strokes but my Biz lost $4M thanks to that idiot Biden so I sold them. Bored I tried RC Nitro, I like the miniature version of engine, suspensionods. Do you have a vid on upper lower needle settings? UK is Best for Motorsports !
You did not mention setting needles when it won’t start
Don't suck on the pressure pipe if you have a full tank of fuel, makes you pull funny faces.
😂😂😂
7:04 I prefer using cringe, I then do not need to cram my face to the model and I can see the fuel line easier czcams.com/users/shortsxbbYzhld-vA?feature=share
Each to their own dude
Sorry for my words but you should work on your explaning skills.
I always get told I explain things too much 😂