MAMBA Stack F722 MINI MK3 F7 Flight Controller
Vložit
- čas přidán 20. 03. 2021
- In this one I'm taking a look at NEW diatone mamba f722 stack. I'm also installing it in my quad so stay with me for a installation guide.
Get yours HERE:
MAMBA stack: www.banggood.com/custlink/vmG...
FRAME: www.banggood.com/custlink/vvv...
MOTORS: www.banggood.com/custlink/3DK...
GHOST rx: www.banggood.com/custlink/vmD...
GHOST board: www.banggood.com/custlink/KGD...
IMMERSION RC vtx: www.banggood.com/custlink/vK3... - Věda a technologie
Hey, does anyone know if you can load I-NAV onto this? It meets the requirements but I-NAV only has the MK-2 in its dropdown menu's.
how high is the stack? What are the precise measurements of the width, length and height including the rubber pads? I have to mount it on a micro apec .. very narrow frame! thak you
Height is 1.3 cm other measurement are standard for 20x20 stack
you have to heat those pads up some more before you tin them no?
Not when you use flux
Did you have to spin the fc wiring harness to stack it on the esc
Kinda don't get the question. I fitted the stack like it was from the box as you can see in the video. And I used original cable that it came with.
@@mrRockwellFPV I bought the same stack when I plug the wire harness in and place the fc on the esc the wire harness is twisted. Is yours the same way?
@@skygroover6692 same here...
My V3 needs twisting
be carefull not to drop any solder into the motors lol
Is this better than the hglrc Zeus ?
I mean it's hard to tell which FC is better. I personally choose FC based on features it has. Like Bluetooth connectivity, type of baro or stack hight. Never came across bad flying FC...
All this and you never measured the height of the stack?
Because of the mounting options its irrelevant. You have 2 kinds of rubber dampers and your standard orings to fit your build.