Great idea. This was actually our first video and would like to make an updated one. When we get to that, absolutely will take your advice. Thank you!!
I haven't started the project yet, but I have a question. What do you do if the metal edging extends 2-3' further than brick wall that the edging should butt up against? Do you bend and it breaks, are there ways to adjust the length of the piece, etc.
On their website it said to overlap the two pieces at an intersection instead of butting them up to each other to avoid cutting. The longer piece would be in the back, the stake would cover the seam like usual
Excellent product- how about a video on how to bend radiuses and make curves?
Great idea. This was actually our first video and would like to make an updated one. When we get to that, absolutely will take your advice. Thank you!!
Love this! Lots! ❤ 👩🌾 🐝🐝
I haven't started the project yet, but I have a question. What do you do if the metal edging extends 2-3' further than brick wall that the edging should butt up against? Do you bend and it breaks, are there ways to adjust the length of the piece, etc.
On their website it said to overlap the two pieces at an intersection instead of butting them up to each other to avoid cutting. The longer piece would be in the back, the stake would cover the seam like usual
How do you put a stake on a 90 degree corner that has two pieces? Do you need a special stake?
You don't need a special stake. Add a stake on each side where the corner butt’s up to the edging.
Onde posso comprar?