Hi kabayan, good to hear from you. The super 270 is a very popular harmonica and the wooden combed model such as yours is still being used up to now. If you surf eBay you'll find quite a number being auctioned, some are of pre-war vintage and most of these have cracked combs or rusting reeds plates. Although it can be serviced the 270 is difficult to maintain - nails were used to fasten the reeds plates and it takes quite a skill to remove them, put them back or replace them with screws.
i have a chromatic hohner which was given to me by my late german grandfather. my aunt said its still from the 1940's it looks the same as yours but its has a different metal cover and is in a wooden box. by the way i'm half filipino half german. hello lolo! :)
Thanks for an informative video. I have an Educator 10 Chromatic that stopped blowing through a couple of holes in December. I followed your instructions (minus the sanitizer device) and now its playing as good as new within 16 minutes of following your directions. Now I'm going to work on a few other old Chromatics that are taking up space in my den.
thanks, will look for nails removal video... my Seydel Bandmaster chromatic is nailed like a nightmare. I have reinforced the opposite side's reed plate one area at a time with a scrap hardware nut (using the nut like a short, fat-walled cylinder-anvil so the hole can let the nail head come out while bracing brass carefully around it) while tapping nail point on the other side's reed plate with small hammer. I hate to shock the reeds with this trauma. The nail heads are now raised enough, perhaps, to pry a little, but don't wish to, of course, damage the reed plate
I’m looking for a slide spring replacement Vir do you have picture of one. Mine was my farthers and I remember it was always in the family so must be around 60 years old
I like the Super 270, it has a clear, distinct sound and very responsive. The main problem, I think, is the comb, it has a tendency to crack, especially in extreme weather conditions and I've repaired quite a number of these. I usually cure the comb with "salad bowl finish" or butcher block oil but I have no idea how far these cured combs can go. If you are a serious harper the more advance version, the Super 270 De Luxe, is the next best alternative.
The valve flaps, like a piece of paper against a headwind. Meron yan 2nd layer, baka nakanganga na kaya at hindi na mapigilan ang pagpaypay ng lower layer. Ang unang hihip butas ay nasa upper reeds plate kung tintugtog ang silindro sa harap ng audience. Meron takip na puting plastic (or leather) ito yong barbula. Eksamen mo, himasin mo para tumuwid. Kung ayaw na baka dapat palitan na . Nakaka-order sa Hohner, sobra-sobra dami, mga beinte piraso bawat isang butas, marami kang reserba.
Hi. Where can I find valves for my chromatic harmonica in the USA? I can't find any online store that sells them. Hohner's website ran out of stock for a long time by now.
I ws about to do the same to my Larry Adler Pro 16, when I discovered that the return spring on the chromatic slide plate was broken. Is it possible to get a replacement?
Part is available from Hohner. Go to "us.playhohner.com" and search for price list. You can do your own replacement with a size 4 safety pin, cut to size.
yes i saw the nails.. and it makes a rattle noise when i blow the number 1 hole. what's wrong with it? i already cleaned it the way you did. (sarap sana mag tagalog) :D
Get a CX12, by the time it took you to put everything on the table , you would've had the CX12 apart in literally 3 seconds time with no tools what so ever.
The CX12 is entirely a different design. Start by removing the slider. Lift the slider button slightly up and pull. Then, remove the bar lock at the back by pressing (using your thumb) on both ends and sliding the bar to left or right to ease out one of the ends. With the bar out the comb-plates assembly falls off easily.
Totally unnecessary and does more harm than good. A complete waste of time and effort. The harmonica was probably cleaner before he started his insane rigmarole.
Thank you for a good demo.
Hi kabayan, good to hear from you. The super 270 is a very popular harmonica and the wooden combed model such as yours is still being used up to now. If you surf eBay you'll find quite a number being auctioned, some are of pre-war vintage and most of these have cracked combs or rusting reeds plates. Although it can be serviced the 270 is difficult to maintain - nails were used to fasten the reeds plates and it takes quite a skill to remove them, put them back or replace them with screws.
i have a chromatic hohner which was given to me by my late german grandfather. my aunt said its still from the 1940's it looks the same as yours but its has a different metal cover and is in a wooden box. by the way i'm half filipino half german. hello lolo! :)
thank you very much for such a good demonstration. I'm going to do the same with mine,and hope to be able to do so without loosing any parts.
Thanks for an informative video. I have an Educator 10 Chromatic that stopped blowing through a couple of holes in December. I followed your instructions (minus the sanitizer device) and now its playing as good as new within 16 minutes of following your directions. Now I'm going to work on a few other old Chromatics that are taking up space in my den.
Thank you for sharing this sir, always wondered how it looks on the inside.
thanks, will look for nails removal video... my Seydel Bandmaster chromatic is nailed like a nightmare. I have reinforced the opposite side's reed plate one area at a time with a scrap hardware nut (using the nut like a short, fat-walled cylinder-anvil so the hole can let the nail head come out while bracing brass carefully around it) while tapping nail point on the other side's reed plate with small hammer. I hate to shock the reeds with this trauma. The nail heads are now raised enough, perhaps, to pry a little, but don't wish to, of course, damage the reed plate
you have the "Bob Ross effect" :)
asmr
Bob ross effect for sure..watch both parts..relax...this guy is great
I’m looking for a slide spring replacement Vir do you have picture of one. Mine was my farthers and I remember it was always in the family so must be around 60 years old
Could you link the video where you replace the nails with screws?
Wow! I have the same exact type of harmonica.
Uau!!! Good job!!! So, Please, I would very much like you to tell me what is the most practical way to buy reed plates for Hohner super chromonica?
I like the Super 270, it has a clear, distinct sound and very responsive. The main problem, I think, is the comb, it has a tendency to crack, especially in extreme weather conditions and I've repaired quite a number of these. I usually cure the comb with "salad bowl finish" or butcher block oil but I have no idea how far these cured combs can go. If you are a serious harper the more advance version, the Super 270 De Luxe, is the next best alternative.
Que?
The valve flaps, like a piece of paper against a headwind. Meron yan 2nd layer, baka nakanganga na kaya at hindi na mapigilan ang pagpaypay ng lower layer. Ang unang hihip butas ay nasa upper reeds plate kung tintugtog ang silindro sa harap ng audience. Meron takip na puting plastic (or leather) ito yong barbula. Eksamen mo, himasin mo para tumuwid. Kung ayaw na baka dapat palitan na . Nakaka-order sa Hohner, sobra-sobra dami, mga beinte piraso bawat isang butas, marami kang reserba.
i just recieved one of these instruments from my grandmother this morning. i would like to know your oppinion on this harp?
After How many Days should we clean the Harmonica?? thanks..
It seemed pretty clean to me at the beginning :-)
The case for your harmonica is beautiful. Where can I get one from?
Hi. Where can I find valves for my chromatic harmonica in the USA? I can't find any online store that sells them. Hohner's website ran out of stock for a long time by now.
I ws about to do the same to my Larry Adler Pro 16, when I discovered that the return spring on the chromatic slide plate was broken. Is it possible to get a replacement?
Part is available from Hohner. Go to "us.playhohner.com" and search for price list. You can do your own replacement with a size 4 safety pin, cut to size.
I want to sale my M.HOHNER the super Chromonica (made in Germany)
I thought ozone had a negative effect on metal...
Many Hohners have their parts made in China, but assembled in Germany.
Great video thanks! Do you know what year these harmonica's were originally manufactured?
It's really help helpful. Thanks a lot.
yes i saw the nails.. and it makes a rattle noise when i blow the number 1 hole. what's wrong with it? i already cleaned it the way you did. (sarap sana mag tagalog) :D
@aerosmusiccom I really have no idea.
4:09 it's called a "registration pin". i suppose.
Mă tem că de atata frecus sa nu le subtii de tot
Pilipino??? Awesome ?!
germany
Get a CX12, by the time it took you to put everything on the table , you would've had the CX12 apart in literally 3 seconds time with no tools what so ever.
+Ray Navarrette How do I open my CX 12!? I'm on this video in an attempt to figure it out.
The CX12 is entirely a different design. Start by removing the slider. Lift the slider button slightly up and pull. Then, remove the bar lock at the back by pressing (using your thumb) on both ends and sliding the bar to left or right to ease out one of the ends. With the bar out the comb-plates assembly falls off easily.
Love the CX12! It’s my main instrument.
💩💩💩💩😅
This is a demonstration of how to do harm and damage to a hated harmonica. I couldn't stand it. Sorry, highly ugly and unnessesary!
Totally unnecessary and does more harm than good. A complete waste of time and effort. The harmonica was probably cleaner before he started his insane rigmarole.
I doubt if you have even seen the inside of your harmonica.
I opened up my harmonica last night and almost vomited