You aren’t joking about the paper instructions. The photos weren’t helpful and the verbiage was written by someone in Kindergarten who’s language is definitely not English.
Very good instructions. I am so glad they had this video in the instructions paper. I went back and forth until I got it right. The only kind of issue I had was with the screws. They looked very similar and I ended up putting the wrong ones to hold the top and bottom of the egg chair.
Bring a third person. Seriously. One to hold it in place, one to fan out the seat, and one to place the screw. Maybe even a fourth if you can spare. This was annoying and the video makes it look simple and instantaneous.
The screws and nuts were already removed and in the hardware bag. Also, can't tell top from bottom. Do you mean choose which side is top and which is bottom?
I don’t think it really matters. The metal base that has more holes goes on the side you choose to be the top. Cause that part will hang. As shown at 1:12 on the video. I hope that helps
Came out pretty good. The included paper instructions are terrible so this video was much needed.
You aren’t joking about the paper instructions. The photos weren’t helpful and the verbiage was written by someone in Kindergarten who’s language is definitely not English.
Very good instructions. I am so glad they had this video in the instructions paper. I went back and forth until I got it right. The only kind of issue I had was with the screws. They looked very similar and I ended up putting the wrong ones to hold the top and bottom of the egg chair.
Bring a third person. Seriously. One to hold it in place, one to fan out the seat, and one to place the screw. Maybe even a fourth if you can spare. This was annoying and the video makes it look simple and instantaneous.
The screws and nuts were already removed and in the hardware bag. Also, can't tell top from bottom. Do you mean choose which side is top and which is bottom?
Mine has a piece of tape on it specifying the Top.
My middle leg doesn’t touch the ground
Make sure you tighten all the bolts down. Could have been put together in 30 minutes if it wasn't for those 24 knuckle busters 😢😢😢😅
Mine was not labeled top or bottom. What do I do?
I don’t think it really matters. The metal base that has more holes goes on the side you choose to be the top. Cause that part will hang. As shown at 1:12 on the video. I hope that helps