How To: Install 1967 Mustang Upper Control Arms
Vložit
- čas přidán 14. 07. 2018
- Today I am installing upper control arms on the 1967 Mustang and documenting the process. Hopefully, this may be of help to someone else in the future.
- Auta a dopravní prostředky
Easier than i thought... will be doing mine this weekend
Nice video , I had a bad experience with Scott drake brand , after I installed my kit,I used my car 3 times then took it to an alignment, the guy at the shop showed me the lower control arms came off the barril , I thought they were made in the usa but sadly came from overseas ,no words
Nice clean job man, thanks!!!!
Did my 68 Cougar yrs before CZcams...have the factory service manual. It never sat down to where it should after, ever come across that? Getting it out of storage soon. Guess I'll double check the manual, I may not of even used it, fairly self explanatory.
what is the torque on the upper control arm bushing nuts? Can the upper control arm shaft be easily serviced/replaced.
How do you access the grease fittings?
what about the shims?
What is the tool you are using to lift and support the rotor?
I always call them a "high hand" but they are essentially an under-hoist jack stand. I believe this is the one I was using in the video:
www.amazon.com/dp/B00AHIWN78/ref=cm_sw_r_cp_apa_i_7rdMFbQEKXFBB
I hope that helps!