How to install a tap on a water tank, barrel/ faucet connecting, Bulkhead tap fitting

In this video I'm going to show you how to install a tap on a water tank, plastic bucket or plastic barrel keep in mind that the main components needed to install a tap on a plastic bucket, water tank or a barrel are the same
So you are going to need the following materials 1. Bulkhead connector 2. A tap 3. thread seal tape 4. Drilling equipment in this case I used three quarters four Inches piece of iron pipe and pliers to drill the hole so if you don't have a drill it's fine
So heat up your metal to get enough temperature to drill a hole
Make sure that you don't drill a very wide hole as this will bring difficulties in sealing of water, just drill a simple hole that your bulkhead can fit
Then put your bulkhead In a correct manner as I did
Wrap a thread seal tape around your tap thread to ensure that there will be no leakage of water
Then connect your tap to a bulkhead
Add water to your tank to check if there is no leakage on the tap
Thank you so much for watching please don't forget to SUBSCRIBE and leave a comment if you have any question or opinion

[@aradia1917]

Thank you very much! I almost went out and purchased a paddle bit until I saw your video. I am so happy I did not waste my money. Thank you again for your lesson. I have successfully and economically installed a tap into my water barrel! Yay!

[@lysch46]

Brilliant. You dont need a technician. You can do it yourself. Thank you. I like it

[@scelilekhuzwayo]

Thank you

[@maltidevi8450]

Beautifully demonstrated. Thank you

[@oakleaman]

Thank you for this video. Wish I'd seen this daaaaays ago.

[@mushitrials9808]

Now you saw it

[@sollnoll9271]

Very helpful thank you!

[@smoothrunner72]

Very good video indeed

[@sober2227]

Thanks bro! Ill just do it instead of buying drum with faucet that cost a lot.

[@martinallen6411]

Lovely video, I found it very helpful.
Peace and goodwill.

[@mushitrials9808]

Thank you

[@sudoegodor891]

Thanks 😊

[@tan6802]

you're a great teacher

[@mushitrials9808]

Thanks

[@hestieful]

Awesome video!!

[@mushitrials9808]

Thanks

[@dhaanizinta1980]

Good idea... amazing

[@leejones982]

Now do it with a deep barrel

[@user-ir7yf7wl7j]

You own conectio from tap

[@ugenegareth9339]

for those who don't have propane tank can use something less expensive like a soldering iron or torch jet lighter
'' 2Esdras2: 33 -100 ll

[@mosessizwe9463]

How about big 2200l tank

[@mushitrials9808]

Do the same

[@azimhanif4789]

can you pls type the name of the connector

[@mushitrials9808]

Bulkhead connector

[@user-ir7yf7wl7j]

You own conectio from tap