Fitting a Tail Tidy / Fender Eliminator

Its crazy how much better the bike looks with one of these fitted. As long as you have the right tools, this isn't as hard a job as you might think, just give yourself a day to play it safe
R&G Tail Tidy - www.rg-racing.c...
R&G Micro Indicators - www.rg-racing.c...
1. Disable your alarm if you have one
2. Remove the seat
3. Remove the 4 grab rail bolts and remove the grab rail
4. Remove the 2 side panel bolts and remove the side panels
5. Remove the 4 fasteners/push rivets
6. Unhook the seat lock cable
7. Disconnect tail light, indicators and licence plate illuminator
8. Remove the seat tail cover
9. Remove the rubber chord holding the ECU in place and rest ECU on the frame - You do not need to unplug it
10. Remove the 4 battery box cover bolts/screws from under the bike and remove the battery box cover
11. Remove the 2 bolts holding the front of the under tray in place
12. Remove the 2 bolts holding the rear of the under tray in position
13. Remove the under tray - be careful as some models may have a fuse holder that needs to be disconnected and re reconnected later
14. If you are using the original indicators, remove them from the old licence plate holder
15. Prepare the new under tray by fitting the indicators to the licence plate holder - Insert rubber grommets if there are any holes
16. Fit the anti-splash guard to the under tray using the 3 plastic rivets
17. Fit the new licence plate illuminator
18. Wrap all new cables in the heat shrink provided and head with heat gun/hairdryer
19. Fit the licence plate holder to the under tray using the 4 new bolts and washers
20. Fit the new under tray using the 4 original bolts - check all wires are routed in the same way as before
21. Using 2 new bolts and 2 old bolts secure the battery box cover
22. Place ECU back in position and secure with rubber chord
23. Position the seat tail cover in place
24. Reconnect the break light/tail light, licence plate illuminator and indicators with new connectors
25. Refit the seat tail cover using original push rivets
26. Refit both side panels
27. Refit seat lock cable
28. Resit the grab rail using the 4 original bolts
29. Refit Seat
30. Refit licence plate - holes may need to be drilled
31. Test everything is working as expected
Follow me on Instagram - / cjmph
Follow me on Twitter - / cjmph
Gear I Use:
Camera: amzn.to/2ojYqtH
SD Card: amzn.to/2pvDBPX
Mic: amzn.to/2ok08eN
Boots: amzn.to/2oRCxoL
Main Tripod: amzn.to/2oIOtqU
Small Tripod: amzn.to/2pvyxLz
Kit Bag: amzn.to/2oIH8aD
Random Other Bits I Use
Paddock Stand: amzn.to/2pvAOXb
Bike Lock: amzn.to/2oRB027
Oil: amzn.to/2pvIbgX