DIY: BobMr2 Removing Some Interior Pieces in Toyota mr2
Vložit
- čas přidán 6. 09. 2024
- This videos is me removing the door panel, center console, cluster, center trim and lower trim by knee in a Toyota mr2 sw20 model
Follow me on:
Ig@BobMr2
CZcams: Bob Pham
Join FaceBook group #Mr2Owners and #SocalMr2division
below are my other DIY for the toyota mr2:
DIY: BobMr2 compression test on Toyota Mr2
• DIY: BobMr2 compressio...
DIY: BobMr2 changing spark plugs on toyota Mr2
• DIY: BobMr2 changing s...
DIY: BobMr2 changing transmission on toyota Mr2
• DIY: BobMr2 changing t...
DIY: BobMr2 changing out E-Brake cable on Toyota Mr2 Sw20
• DIY: BobMr2 changing o...
DIY: BobMr2 swapping turbo on 3sgte gen5 • DIY: BobMr2 swapping t...
DIY: Fuel Level Sensor Diagnose / Replacement for Toyota MR2 SW20
• DIY: Fuel Level Sensor...
DIY: BobMr2 change Shifter Cables on toyota mr2 sw20
• DIY: BobMr2 change Shi...
DIY: BobMr2 installing complete 94+ “ kouki “ tail lights on Toyota Mr2 ...
• DIY: BobMr2 installing...
DIY: Installing Coilovers on Toyota Mr2
• DIY: Installing Coilov...
DIY: Fix steering wheel column cover for toyota mr2
• DIY: Fix steering whee...
DIY: Replacing gen4 3sgte fuel injectors on toyota mr2 sw20
• DIY: Replacing gen4 3s...
DIY: change ss brake lines on Toyota Mr2 sw20
• DIY: change ss brake l...
DIY: How to roll fender on mr2
• DIY: How to roll fende...
DIY: Installing Coilovers on Toyota Mr2
• DIY: Installing Coilov...
DIY: 3SGTE GEN 3,4,5 TIMING BELT KIT
• DIY: 3SGTE TIMING BELT...
Sw20 mr2 e153 LSD vs non-lsd transmission axles
• Sw20 mr2 e153 LSD vs n...
DIY: 45mm Omori boost Guage into mr2 cluster
• DIY: 45mm Omori boost ...
DIY: Toyota Mr2 sw20 engine/gas tank drop
• DIY: Toyota Mr2 sw20 e...
DIY: how to make 3sgte gen4 fit into toyota mr2 Turbo sw20
• DIY: how to make 3sgte...
Diy: Installing front solid molding for Toyota MR2
• Diy: Installing front ...
DIY: Changing Alternator on Mr2 Turbo sw20
• DIY: Changing Alternat...
DIY: TOYOTA MR2 AXLES CHANGE
• DIY: TOYOTA MR2 AXLES ...
DIY: How to compression test engine by it self w/o car
• DIY: How to compressio...
DIY: Toyota MR2 sw20 - Fix Strip fog lights bolts.
• DIY: Toyota MR2 sw20 -...
DIY: change coolant on Mr2 sw20 3sgte
• DIY: change coolant on...
DIY: Change Transmission oil on sw20 mr2 3sgte e153
• DIY: Change Transmissi...
DIY: oil change 3sgte Gen4 Mr2 sw20
• DIY: oil change 3sgte ...
Bob I love your passion about these vehicles its shared by few! Thank you for restoring these!!!
Thank you so much!
Bob. Also a side note. When the door panel is removed for what ever reason. Vaccum the lower inside part of the door and spray some lube (water displacement). The drain holes can slowly get clogged and not allow the water to drain and will rust the door out.
Teddy Portuano nice. Thanks for that info. I never notice any rust . Prob CA cars don’t see much rain. 🤷🏻♂️
@@BobPham man. I see that a lot over here in south Florida.
Great video, Bob. Thanks for helping us MR2 noobs out.
Very thorough. Lots of good tips on what to look out for. Thanks for posting.
So now I know. Thanks.
Thanks man I needed a tutorial like this
The cable speedo is a nightmare the first time around.
Many thanks for info. Admire your tenacity.
Thx for the video Bob. Quick question. When I am in the highway, I get a lot of wind noise coming from the Twitter speakers in the door. I already changed weather on doors. If anyone can help, that would be great. Thx
nice seats
great vid! can you do the rear panels for the speakers and how to remove the carpet?
Anyone who’s looking for this, I recently went to do this.
First you want to remove the door sill panels.
Then the lock box behind the seat (similar panel for driver side has three pushpins holding it down rather than a lock, three philips screws on each side at hinge of panel.)
Then the panel covering the rear speakers should pop straight out towards the inside of the car.
I think there are around 4 or 5 push clips holding it in.
Great info!
How easy or expensive to replace the entire dash? Looking at a MR2 for sale that has some curling on the vents towards the windshield.
Kai Takahash good half day of work. Finding a good dash is hard. Join the Facebook group Mr2Owners for info.
@@BobPham Thank you for the info and keep up all the good work! Do you know of any good 2nd gens on the market?
Hey Bob, I'm curious to know which Pioneer digital multimedia reciever you have towards the end of this video. -Thank you
Thank you
Great tutorial
I like an idiot pried from the black any way to fix the switch ? ?
Good info. Thank you.
What is the panel called that’s by the passenger door that holds the ecu/ glove box
@bobpham wanna sell a complete set of kouki tails?
Is it possible to install the center console box in a NA car that never originally had the box? I can't find anything about it anywhere
Owen Hoover yea. U need the box bracket and screws and cut up your carpet and
I swear to god the trim on these cars are the most shitty I have ever dealt with
Hey bob do you happen to have the right rear kouki tail light for sale ? Thx
Angel Amaral no sorry.
Only left ones are for sale at the dealer.
I only have complete sets only.
Bob Pham how much if you would sell ?
$700 for the used set. $950 for the restored ones. U can sometime find cheaper on the fb market place or eBay.
Bob Pham another question, how do you smog your gen4 swaps here in California?
do you know somewhere I can buy interior panels
Got any window switches for sale? I just need the Switches cause mine is rhd.
Anyone make repair tabs for the window switch trim? Previous owner broke it and my filament printer is not accurate enough to print the part correctly.
[ Slimeade ] twosrus sells reproduction ones.
Bob Pham 😭 thanks! I didn’t think anyone would have it in blue