Reptile Cloud 149 v2 Frame Overview and Quick Build.
Vložit
- čas přidán 29. 08. 2024
- Looking into the reptile cloud 149 v2 3 inch cinewhoop frame, design, build options and performance. Frame weighs 105 grams.
Is the Protek 25 too small or the Protek 35 too big? here's a good middle ground
I got mine from here
bit.ly/3Mcs8vj
**For the robots**
cinewhoop 3inch drone rush tank fpv freestyle vtx iFlight protek35 Protek25
Clean 🔥
What about 30x30 stack? After mount all together will it fit?
A 30x30 stack will not fit. There will be no room for the VTX even if you find some way to make it fit. You need a AIO board
I've fit a 20x20 stack nd a tiny analog VTX as well like the one shown on the video but it was a very tight fit. You will need O rings to sperate the stacks to provide just enough room.
Can I mount vista inside on AIO?
Hi! How did you connect the LED circuit board? Would you mind sharing the diagram? Thanks!
Unless you have a FC with D+ D- ports for the USB port, you can only use buzzer and led wires. GND goes to GND and LED goes to LED on your FC. BB+ goes to 5v or BB+ or BZ+ pad on your FC and BB- goes to BB- or BZ- or GND on your FC
Any way you could let me know if my reptile cloud 149 drone has a receiver and how to connect it? Absolute beginner and I'm completely stuck. Bought it a long time ago and I'm not sure how to set it up.
If you look at the back of the drone and you see 2 wires / antennas sticking out then it probably has a receiver. Do you know if your order was a BNF or a PNP? Either ways, what remote controller do you have?
I have a Taranis qx7, and there’s only the little bulb antenna with one black wire on the back end,
What reciever did you use?
ExpressLRS
What motors did you use for this build?
At first I used 2105.5 motors. A bit over kill. So I switched to 1408 motors.
@@OdysseusVrakas thanks a lot!
@@OdysseusVrakas what do you think of 2004 motors?