Radar Plotting - Basics (Calculating CPA, TCPA, Course, Speed and Aspect)

This video shows the basics of radar plotting using an example. The video teaches the viewer how to calculate the CPA, TCPA, course, speed, and aspect of the target from drawing a radar plot.

[@mfaisal2873]

Thank you very much Sir,your lecture is always the most helpful Sir.

[@sujittamang1802]

ONE OF THE BEST EXPLAINATION... EVERY DETAIL.... KEEP IT UP SIR

[@josephadereni8202]

Suggestion, write The question in the video description.

[@samn1807]

GREAT VIDEO SIR. SO HELPFUL

[@turcenoarthurjamil4364]

sir I have 3 observation...and then I can't make a straight line because they are a little bit offset to each other...for me to make the straight line should I only refer to the first and last observation to make the RML???

[@altamashkhan676]

YOUR VIDEO HELP ALOT SIR ! THANK YOU SOO MUCH

[@hanifmuhammad6457]

Very nice sir Jee 👍

[@falaksh]

Good explanation simple and easy

[@deymhahaha9408]

Hi sir can you please tell me what is the step by step on how to operate ARPA please reply asap

[@hanifmuhammad6457]

Sir can u explain Any Rendezvous ASAP question

[@raypetersen8273]

If incoming vessel speed is 6 knots then your vessel speed is 4 knots in order to travel 1nm per 6 minutes cannot be 12 knots?

[@turcenoarthurjamil4364]

WA speed is 6 knots?

[@beterefe]

I was in tune up until you plotted own course and speed. . Everything before that was a breathe

[@anjusahu123]

Sir can you clarify me whether the speed is SOG OR STW

[@workjdupreez]

Speed through the water

[@arunhari8967]

Board is not fully visibled .

[@ezrakipkoech1425]

Great video...I have a querry lets say if the CPA is 0.5 nm and you proceed with the course and speed relative with the other vessel....Will you pass ahead of the other vessel by 0.5nm or will the other vessel pass ahead of you by 0.5nm?

[@BoxerSonnyboyWatts]

Is the CPA ahead of you or astern of you?

[@ezrakipkoech1425]

@@BoxerSonnyboyWatts It is ahead of you 😊

[@bhushanranalkar5743]

Sir ,can't see upper right corner.

[@AnubhavSingh259]

please speak a little louder next time
Thanks for the video

[@AbhishekSingh-ce7mo]

Sir please make a video on UTM projection from Charts chapter of Navigation.. i am unable to understand it

[@captankadhir2567]

where is the question sir
where you writing i did not know
correct that mistake after very useful to us
otherwise this video is good one

[@ManojKumar-ny7xz]

sir volume itti bi km mt rkho ki pc me guss k sunna pde. pls say it loud

[@SteeringMariners]

hahaha...ok...noted:)

[@kuldeepsingh-fh5bi]

Vdio to puri dikhooao

[@graham6229]

very poor sound on this one Sir