Steering Wheel Removal and Refitting - Nissan Micra K12
Vložit
- čas přidán 17. 10. 2022
- How to remove and replace the steering wheel on a 2003 to 2010 Nissan Micra K12. WARNING: Attempt this fix at your own risk. Working on or near the airbag unit could be very dangerous so use extreme caution !. Disconnect the battery at least 5 minutes before you begin, to disable the airbag system, and leave it disconnected until the work is fully completed. After you disconnect the airbag connectors, do NOT probe the airbag terminals or connectors with a test meter as this could risk triggering the airbag. If you are in any doubt, take the car to a Nissan specialist or garage and have a fully qualified mechanic carry out the procedure. Thanks for watching. Please comment, like and subscribe !.
All of my uploaded material is protected under copyright law. None of my videos may be re-uploaded, reproduced or transmitted, in part or in full, in any form or by any means, without the written permission of the copyright holder.
© / screwsnutsandbolts 2022
Read important information below:
Disclaimer
Under no circumstances will Screwsnutsandbolts be responsible or liable in any way for any content, including but not limited to, any errors or omissions in the content, or for any loss or damage of any kind incurred as a result of any content communicated in this video, whether by Screwsnutsandbolts or a third party. In no event shall Screwsnutsandbolts be liable for any special, indirect or consequential damages or any damages whatsoever resulting from loss of use, data or profits arising out of or in connection with the availability, use or performance of any information communicated in this video. Due to factors beyond the control of Screwsnutsandbolts, it cannot guarantee against improper use or unauthorized modifications of this information. Screwsnutsandbolts assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. Screwsnutsandbolts recommends safe practices when performing any do it yourself repairs and or with tools seen or implied in this video. Due to factors beyond the control of Screwsnutsandbolts, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not Screwsnutsandbolts. - Auta a dopravní prostředky
Thanks a lot Can you please do one on how to change the bulbs in the speedometer please for nissan micra
Which bulbs have failed ?
Thanks for sharing this important info
👌
Thanks !
Tanke you very much for explication 👍✌️🌹
No problem 👍
Hi the torx screw was slightly stripped when I came to it and very tight, I managed to strip it more and I can’t get it out. Any advice?
You'll probably have to use one of those screw extraction tools like this one: czcams.com/video/tbjAeHTMipE/video.html
@@screwsnutsandbolts Managed to get it out, but now i got an airbag light and doing the reset doesnt seem to work
Great. Could you also do a quick one how to fix steering wheel adjustment? When locked my steering column moves up and down freely, so I cannot raise my steering wheel and keep it at desired level. Micra K12.
Is the adjuster lever under the steering column fully locked into place ?
I have one retaining screw that doesnt go out it just turns and stay in the same position any idea how to remove it?
The screw is definitely rotating in there ?
If you pause the video at 2:32 you can see where the nuts are fixed to the rear of the airbag. The nut must have broken away from the unit and is now rotating with the screw. I'm not sure how to remove that to be honest.