So far so good, I had to roll my fenders in the front. I haven't tested it as hard as I'd like but hoping to before LS Fest. I think I need a sway bar for my rear but that may have to wait till next year so I can engineer sprint car bars to work with what I have I autocross Ed a few times previous years and never really put it through it's paces but I added a front sway bar that has not been autocross tested yet
@@woody2745 I'm excited to see your progress on the track since last year, haven't seen much of you on SNS but I haven't been on much either, kinda been too busy working on the Methtrap!! What are you doing in the rear for the sway! Bolt or welded setup? I'm still toying with a ton of ideas about detachable sway system so I can remove two clevis pins fromt and rear and drag race, then put them back in for cross/canyon carving... Coilovers permitting
@@AndrewReiwitch-sw9lfbasically since my rear end has bind and I threw the biscuit links on there I may experiment with different durometer bushings to get different roll stiffness I did however blow up the engine on Saturday haha, so I'll be putting my effort into getting another one built in 2 months for LS fest I was on SNS a lot when I was logged in on my phone and off social media, I've been super busy lately getting married and with life events I'll have to log back in, update everyone and catch up on the methtrap!
@@woody2745 congratulations on getting hitched!! Awesome!! Not so awesome is the blown motor 🤦♂️ Bummer but... Always room for improvement, right?!? I too have been less and less on the social media (SNS and IG are my only platforms except here) and trying to get work done on my ride. Lots to do!!! Glad you're well, and again... Congratulations!!!🤘🤘🤘👍
That front mount setup looks killer!
Fire in the hole 🔥
Fire…..working!!💯
Uncle buck approved👍
Yeah buddy!!!!!
How's that busa susp holding up?
So far so good, I had to roll my fenders in the front. I haven't tested it as hard as I'd like but hoping to before LS Fest. I think I need a sway bar for my rear but that may have to wait till next year so I can engineer sprint car bars to work with what I have
I autocross Ed a few times previous years and never really put it through it's paces but I added a front sway bar that has not been autocross tested yet
@@woody2745 I'm excited to see your progress on the track since last year, haven't seen much of you on SNS but I haven't been on much either, kinda been too busy working on the Methtrap!!
What are you doing in the rear for the sway! Bolt or welded setup? I'm still toying with a ton of ideas about detachable sway system so I can remove two clevis pins fromt and rear and drag race, then put them back in for cross/canyon carving... Coilovers permitting
@@AndrewReiwitch-sw9lfbasically since my rear end has bind and I threw the biscuit links on there I may experiment with different durometer bushings to get different roll stiffness
I did however blow up the engine on Saturday haha, so I'll be putting my effort into getting another one built in 2 months for LS fest
I was on SNS a lot when I was logged in on my phone and off social media, I've been super busy lately getting married and with life events
I'll have to log back in, update everyone and catch up on the methtrap!
@@woody2745 congratulations on getting hitched!! Awesome!! Not so awesome is the blown motor 🤦♂️ Bummer but... Always room for improvement, right?!? I too have been less and less on the social media (SNS and IG are my only platforms except here) and trying to get work done on my ride. Lots to do!!!
Glad you're well, and again... Congratulations!!!🤘🤘🤘👍