Band Fabrication Demonstration: Dr. Amita Rai, 2018

Sdílet
Vložit
  • čas přidán 7. 09. 2024

Komentáře • 19

  • @dr.amitarai.4541
    @dr.amitarai.4541  Před 6 lety +3

    PLEASE TURN ON THE SUBTITLES IF YOU NEED

  • @shikhabantawa5495
    @shikhabantawa5495 Před 6 lety +1

    wow!! grt job amita... hoping for more videos

  • @missmedico4599
    @missmedico4599 Před 5 měsíci

    Very informative video ❤

  • @AshishKumar-tm3is
    @AshishKumar-tm3is Před 3 lety

    Beautiful video.. thanks for sharing 🙏🙏

  • @saikatsaha456
    @saikatsaha456 Před 3 lety

    Thank you so much mam for this vedio..its really helpful

  • @mahalaxmishah1735
    @mahalaxmishah1735 Před 3 lety

    Thank you ma'am..!

  • @madhavjandial4699
    @madhavjandial4699 Před 3 lety

    Ty mam for making this vid we o

  • @luise.pisons.2829
    @luise.pisons.2829 Před 6 lety

    Thank you so much Dr. Amita!
    I was in need of guidance :)
    by the way... is there an alternative plier to pinch the band for adapting it?
    question 2: Should the soldered joint be polished?

    • @dr.amitarai.4541
      @dr.amitarai.4541  Před 6 lety +1

      It's my pleasure Luis
      PEOPLE USE CURVED HOE PLIERS ONLY ALSO, BUT WHEN COMPARED BAND PINCHING PLIERS GIVES BETTER ADAPTATION, (MIND IT: ITS DIFFICULT TO GET USED TO WITH PINCHING PLIERS AT FIRST, BUT ONCE YOU ARE USED TO IT, IT'S VERU EASY AND LESS TIME CONSUMING)
      IF THE SOLDER MATERIAL IS EXCESS OR INTERFERING WITH OCCLUSION, THEN WE HAVE TO TRIM AND POLISH THE SOLDERED JOINT
      EVEN IF TRIMMING IS NOT DONE THEN WE CAN USE FINE SAND PAPER AND ZINC PHOSPHATE CEMENT WITH GAUGE, TO GIVE IT SHINY APPEARANCE

    • @luise.pisons.2829
      @luise.pisons.2829 Před 6 lety

      Thank you for taking the time to answer and making this video. Im an orthodontist in formation and i found a bit hard to find good quality information on this subject. Have a great weekend Dr.

    • @dr.amitarai.4541
      @dr.amitarai.4541  Před 6 lety

      :) YOU TOO HAVE A GREAT WEEKEND

  • @MM-zp8iy
    @MM-zp8iy Před 4 lety

    Can i know when to use straight hoe and curved hoe pliers?

    • @dr.amitarai.4541
      @dr.amitarai.4541  Před 3 lety

      Hi sorry for late response, I usually use hoe pliers before band pinching pliers for initial adaptation. When to use curved or straight hoe pliers depends on the access you will be needing. I use curved hoe pliers more than straight ones.