replacing injector cups in a d12 Volvo big rig
Vložit
- čas přidán 12. 09. 2024
- This is a short version of how to replace injector cups and the tools needed on a d12 liter Volvo truck THE TOOL NEEDED IS BY KTC VOL1516 Volvo sleeve remover and installer,it comes in a 4 piece kit
The tool needed for this job is a kit by KTC Vol1516
Hi bro, this is the same tools for TAD 734 GE?
The tool for the d12 and 16 are the same?
I am not sure I have never been inside a 16
Hi bro, do you know the references of the tool to remove injector sleeves of volvo motor TAD 534 GE?
Sorry but I am only familiar with the d12 and 13-liter volvo ,
Can you use old injectors again?
Yes for sure I always due unless I have a misfire. Just get a complete set of 0-rings and replace them, you won't use all they give you.. Just make sure they are in the "Right groove" When you install, there are grooves that the ring fits but there are also empty grooves,.just be sure! Wrong grooves or the ring is not good. just compare it with the old one.
How do you know the piston is not at the top? Thanks
Take a long skinning philips screw driver and stick it down the injector hole ,you need to be down a couple inches to be safe
@@alhoot727 thankyou 🙏
Nosal bus baithane wala
Apna number daliye bhai